What did you do to your NNBS GMT900 Tahoe/Yukon Today?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

1BADI5

Supporting Member
Joined
Feb 2, 2014
Posts
1,833
Reaction score
2,988
Location
DMV
...........and of course the shop it running late; won't be ready til tomorrow morning.

..............and why the f&*k not, my FAST LSX gasket kit I ordered last Monday that was supposed to arrive Friday has been just sitting in F%^kin Akron for ***** and giggles. Need the special sized O Rings to install my new injectors........I never reuse injector O Rings.

No matter how much you plan........everyone else points and laugh while say F$%k your plan. Time for a drink.
 

iamdub

Full Access Member
Joined
Apr 23, 2016
Posts
20,821
Reaction score
44,932
Location
Li'l Weezyana
Maybe. We found a hand sized wet spot of water under the cargo liner in the back today. My daughter said she could make out the faint outline of water stains at the back of the headliner. I guess it's time to pull the roof rails off and reseal them?

I've been parked outside for a couple weeks now and when I opened the rear to get some stuff out, I had a wet spot on the right rear corner of the floor liner. I could see a faint outline in the headliner directly above it. I didn't see any evidence that it was leaking through the wire boot, so I'm assuming it's a leaky roof rack screw. I guess it's time to weld 'em shut and repaint the roof.

...Or rearrange the shop so I can park in there again.
 

George B

¯\_(ツ)_/¯
Joined
Feb 5, 2020
Posts
7,769
Reaction score
18,599
Location
Oconomowoc, Wisconsin 53066
Quick vacuum job since my boy eats like cookie monster and has a fugging mess back there. All cleaned up and wiped down again.
Stupid Weather tech liner on the drivers floor pulled the keeper through the carpet. Damn things are JUNK! I would never buy weather tech liners! I Need better all weather liners that don't slip around.
 

ls1frc

Full Access Member
Joined
Aug 10, 2019
Posts
923
Reaction score
1,350
I have Husky Liners. There is a little screw fitting, but I don't see a hole anywhere to screw it into in my existing carpet? The little exposed hole always collects dirt.
 

Doubeleive

Wes
Supporting Member
Joined
Nov 7, 2017
Posts
26,126
Reaction score
39,089
Location
Stockton, Ca.
I have Husky Liners. There is a little screw fitting, but I don't see a hole anywhere to screw it into in my existing carpet? The little exposed hole always collects dirt.
your supposed to just twist it into the carpet I never put mine in, the liner doesn't move maybe a inch sideways sometimes
 

ls1frc

Full Access Member
Joined
Aug 10, 2019
Posts
923
Reaction score
1,350
your supposed to just twist it into the carpet I never put mine in, the liner doesn't move maybe a inch sideways sometimes

Seems like it would ruin the carpet. I think I'll just cut the screw part off and silicone it in place or something then.
 

Doubeleive

Wes
Supporting Member
Joined
Nov 7, 2017
Posts
26,126
Reaction score
39,089
Location
Stockton, Ca.
Seems like it would ruin the carpet. I think I'll just cut the screw part off and silicone it in place or something then.
ya that's what I figured would happen as well, that and I take them out from time to time to clean them. It stays in place just fine I have no complaints there good liners
 

Forum statistics

Threads
132,205
Posts
1,864,005
Members
96,733
Latest member
sparky 843
Top