What did you do to your NNBS GMT900 Tahoe/Yukon Today?

[shreksbrother]

Unless you have 2" drop spindles.

My 03 was lowered with spindles. This is a PPV, so it already looks a bit lower than stock [emoji4]

Plus I recently moved to Michigan, and I don't want my Tahoe to be a snow shovel!



Sent from my Galaxy Note9 using Tapatalk

 

[randeez]

Drop spindles and front axles....

I changed one of my fronts, didnt pull axle or pop ball joint
Just loosened all, removed bottom 2, and unthreaded the top 1 as I pulled the hub out. Couldn't change that top bolt tho

 

[Drok]

I’m beginning to wonder if GM full size SUVs and trucks only have evap OBD codes available in the ECM...

Finally after a little over a year since my wife bought her current one, it threw P0455 code today. Her 07 had nothing but them (and probably ALL of them, too... uggghhh) when ever it threw a code or two, my Silverado throws occasional P0454 and I don’t remember a time any of previous ones would’ve thrown any other than an evap code.

Cleared it and hope it won’t come back anytime soon. And of course it threw it just when I was planning to get it inspected in the next couple of days.

Ive replaced the evap canister and it was gtg for a week and now im getting the whole clicking off every few seconds of getting gas again. No codes have shown up. So im at a loss and annoyed haha

 

[shreksbrother]

Replaced the worn out, nasty PPV rubber steering wheel with a good used leather one from eBay! And now I have steering wheel controls for my radio.

Sent from my Galaxy Note9 using Tapatalk

 

[Tonyrodz]

Replaced the worn out, nasty PPV rubber steering wheel with a good used leather one from eBay! And now I have steering wheel controls for my radio.

Sent from my Galaxy Note9 using Tapatalk

Was it pnp, or did you need to change the clock spring?

 

[shreksbrother]

Was it pnp, or did you need to change the clock spring?

Completely plug and play [emoji4]

Sent from my Galaxy Note9 using Tapatalk

 

[Doubeleive]

Ive replaced the evap canister and it was gtg for a week and now im getting the whole clicking off every few seconds of getting gas again. No codes have shown up. So im at a loss and annoyed haha

Might want to change the solenoids as well there is one by the tank and one under the hood on the intake

 

[Doubeleive]

Got the Wade floor liners today noticed a big gap it makes by the door hinge, I was going to send them back but then I said screw it and just cut that piece off, passenger side fit much better I'll give them a few days and see how they do I have big feet and always end up pushing the floor liners up under the pedals.

 

[tsuintx]

Ive replaced the evap canister and it was gtg for a week and now im getting the whole clicking off every few seconds of getting gas again. No codes have shown up. So im at a loss and annoyed haha

Freaking annoying, huh? Hers luckily doesn’t have that crap going on. At least not yet...

Sure hope that code was just a fluke...

 

[Drok]

Might want to change the solenoids as well there is one by the tank and one under the hood on the intake

Ok will do

Freaking annoying, huh? Hers luckily doesn’t have that crap going on. At least not yet...

Sure hope that code was just a fluke...

Heck yea it is. Especially since its almost winter and I dont want to spend 30 mins filling the tank in negative weather haha