now it's time for new tires, then it goes to the transmission shop probably right after Christmas if not sooner
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
- Thread starter phattyford
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Don’t think so, it’s in a turn lane. Better NOT drive straight.
R3cord303
Posse In Effect
Here’s all thats left of the bearings on that side
wjburken
Supporting Member
We ARE talking about the curb hopping master here, so.........
R3cord303
Posse In Effect
Man that light setup looks slick as hell. If mine was the same color as yours I’d do all that and a debadge.
Sorry but lol. Thems gone.
Had an intermittent stabilitrac message and ABS light for quite some time,until it finally was always there. No drive issues. A friend has HP Tuner program so we hooked up and gathered the stock Programming and ERROR code. C0045, left rear wheel speed sensor.
Ordered an AC Delco unit from Rockauto and installed.
Fixed. No light or error messages
Ordered an AC Delco unit from Rockauto and installed.
Fixed. No light or error messages
swathdiver
Full Access Member
She's lit up like the Vegas strip!
R3cord303
Posse In Effect
Yep
alpha_omega
Full Access Member
Might be worth checking your grounds and the purple wire running to your gas pedal. A few years ago I had the same issue and it went into limp mode every so often. Showed up as wheel speed sensor but turns out that wasn’t the issue. One of the grounds in the back needed cleaning, the passenger side pillar ground was “meh...ok”, but I cleaned it anyways and adjusted the harness hack job running to the pedal. Been right as rain ever since.
