What did you do to your NNBS GMT900 Tahoe/Yukon Today?

[Just Fishing]

I don't even know what this is, but i don't think my transmission or rear end could handle it.
https://www.summitracing.com/parts/nal-19417352

 

[Idriveaho]

LMAOP.......that's the same one I started with and was horrible

Get this one and you'll be golden!

https://www.amazon.com/gp/product/B08NDM84DJ/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

You will also need this to

https://www.amazon.com/gp/product/B000COC7ZU/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1

I had my air compressor set to 90 psi and was good to go. Once you pull all of your rockers give the retainers a nice bump with a non-metallic deadblow

i have that one except mine didn’t come with the storage case.

 

[1BADI5]

i have that one except mine didn’t come with the storage case.

I was a puzzle trying to get it to fit in that little box

 

[Rocket Man]

I don't even know what this is, but i don't think my transmission or rear end could handle it.
https://www.summitracing.com/parts/nal-19417352

It even has a $100 rebate on that $4000 engine block. But if you’re dreaming, how about the Chevrolet performance LT4 connect and cruise, with the Corvette Z06 engine and the 8l90 trans along with everything you need to get it running. Supercharged 650 HP that can be modded for some serious power.https://www.chevrolet.com/performance-parts/connect-cruise-powertrain-systems

 

[Drok]

It even has a $100 rebate on that $4000 engine block. But if you’re dreaming, how about the Chevrolet performance LT4 connect and cruise, with the Corvette Z06 engine and the 8l90 trans along with everything you need to get it running. Supercharged 650 HP that can be modded for some serious power.https://www.chevrolet.com/performance-parts/connect-cruise-powertrain-systems

damn. Lol

 

[Sobro]

Sounds tasty, but I don't think that setup is suitable for towing.

Today I found out that the US Postal Service Priority Mail shipment from Black Bear Performance in Idaho to me in Nashville mailed on the 16th first went to Spokane and then to Rochester, New York where it is taking Spring break, apparently.

 

[wsteele]

I guess a lot of trucks and park next to me because mine seem too low

Sent from my SM-G930V using Tapatalk

Just to close the loop, I finally got a shot of my door protector.

Attached is a picture of my door protector strip. The picture only captures a few, I counted 30 total on the drivers side. These were gotten in the last 26 months (time since they were last refinished by my body shop).

I did notice 2 that were above the major bulge of the protector, likely from taller trucks, but zero above or below the strip. We have a lot of lifted trucks and SUV's in our neck of the woods.

All 30 likely would have been some amount of denting on the metal of the doors without the strip.

Looking at your picture, it does appear like your strip on the Denali are lower (could be an optical illusion) and also, it looks like the profile of the strip on the Denali might be a little flatter, which may allow intruding doors to get to the metal above the strip.

I didn't like the strips when I first bought the truck (thought it detracted from the aesthetics). but now I love them. Just one more reason to keep the old gal forever.

 

[George B]

Anyone have a writeup of removing the rear bumper pad? My new chrome strip arrived.

 

[CHOO CHOO]

Need some help on getting new tires for the 24's. I had some knock off nankang brand from ebay(actually wasn't a bad tire imo) but looking for a new set. Besides nitto 420s, what's a good recommendation.

A friend from work can get these general grabbers for fairly cheap imo. Anyone have any experience with them?

Sent from my Pixel 3 using Tapatalk

 

[Rocket Man]

Just to close the loop, I finally got a shot of my door protector.

Attached is a picture of my door protector strip. The picture only captures a few, I counted 30 total on the drivers side. These were gotten in the last 26 months (time since they were last refinished by my body shop).

I did notice 2 that were above the major bulge of the protector, likely from taller trucks, but zero above or below the strip. We have a lot of lifted trucks and SUV's in our neck of the woods.

All 30 likely would have been some amount of denting on the metal of the doors without the strip.

Looking at your picture, it does appear like your strip on the Denali are lower (could be an optical illusion) and also, it looks like the profile of the strip on the Denali might be a little flatter, which may allow intruding doors to get to the metal above the strip.

I didn't like the strips when I first bought the truck (thought it detracted from the aesthetics). but now I love them. Just one more reason to keep the old gal forever.

View attachment 273752

Wow. I don’t have door protectors on my 02 and zero door dings over it’s 19 year life. Maybe people see that protector and bang into it on purpose. Or maybe people where you live are just assholes! Sheesh that’s terrible.