Thanks, just a dremel and cheap plastic welder from harbor freight
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
- Thread starter phattyford
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
iamdub
Full Access Member
Sparksalot
Supporting Member
You still go to the mall?
gooffeyguy
Tom
Food court is where it's at!
RooTBeeRthe1st
Full Access Member
- Joined
- Jul 11, 2018
- Posts
- 1,087
- Reaction score
- 2,470
My mind is blown.
iamdub
Full Access Member
For my daughter. Was returning some shoes to the store instead of dealing with the return label and dropping off BS.
iamdub
Full Access Member
Dos Bros and a good vantage point to creep on the single MILFs.
iamdub
Full Access Member
Did such a good job that it kinda looks photoshopped.
Drove it across a creek, up a hill and into a cow pasture at our friends’ farm so the kids could meet some cows.
iamdub
Full Access Member
Finally finished the evaporator core cleaning and cabin filter retrofit-
Bought a piece of 16" thin wall PVC pipe (some kind of pre-made sink connector piece) then softened it with the heat gun to flatten it. Ugly but very functional. Taped it to the shop vac with painter's tape cuz that was the first tape I could get my hands on and I didn't have many fcuks left to give with this project:
Still looks gross but it's a lot better than what it was and I was over leaning into the floorboard at this point:
Holding filter in place for the pic:
Closure installed.
I left the blower on high with all vents closed except for the one on the far right of the dash so I could reach it to feel. I didn't notice any excessive reduction in volume out of the vent. Doesn't matter, it's done. Spent most of the time getting that screw in front of the subwoofer installed.
Bought a piece of 16" thin wall PVC pipe (some kind of pre-made sink connector piece) then softened it with the heat gun to flatten it. Ugly but very functional. Taped it to the shop vac with painter's tape cuz that was the first tape I could get my hands on and I didn't have many fcuks left to give with this project:
Still looks gross but it's a lot better than what it was and I was over leaning into the floorboard at this point:
Holding filter in place for the pic:
Closure installed.
I left the blower on high with all vents closed except for the one on the far right of the dash so I could reach it to feel. I didn't notice any excessive reduction in volume out of the vent. Doesn't matter, it's done. Spent most of the time getting that screw in front of the subwoofer installed.
Last edited:
