Gzes
the drifting 2dr
Ok yea im floor 4x4 its just gonna sink a lil not a problem. Howd u get the shrpud back in?
What did you do to your OBS GMT400 Tahoe/Yukon Today?
- Thread starter 96ProCompTahoe
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
SPLmonster13
Full Access Member
Looks damn good!
I'm about to throw the rcx on top of my 3" body.
---------- Post added at 11:18 PM ---------- Previous post was at 11:18 PM ----------
I just used the extender bolts it came with, and took my time...
I'm about to throw the rcx on top of my 3" body.
---------- Post added at 11:18 PM ---------- Previous post was at 11:18 PM ----------
I just used the extender bolts it came with, and took my time...
Gzes
the drifting 2dr
Did u have to remove the clutch fan? I think im gonna have to and i should have to do some trimming i believe
SPLmonster13
Full Access Member
I did have to notch mine for the lines, but I didn't remove the clutch. However, I've known some who have
SunlitComet
OBS Jedi-Do Good
the plastic lines are used because they hold their shape with out needing supports for long lengths. they get old some times.
They last longer than rubber hoses too. He should be thankful he isn't working on some 80s carburetor with 3 miles of vacuum hoses.
Finally put my new cap on today. Here is picture of the of the old one
SunlitComet
OBS Jedi-Do Good
like the old Nissan's or toyota's i think. hose routing label was like a damn maze with like almost 2 dozen or more all going to the same block mounted on the firewall. crazy stuff but it did the job mechanically for emmisions what electronics did for it in the '90's.
Gzes
the drifting 2dr
So the blocks are in didnt break anything else but a body bolt that was gone.... Oiled the hell outa it and smacked it around so tomorrow im gonna heat it smack jt and oil it again then try n weld a nut and get it out
Similar threads
