axekick
Full Access Member
My blower motor resistor had gone bad so I bought one of the new ones where you have to splice a few wires for the install. I tested it before i put it all together and it worked but when I was installing it I shorted the hot wire to the ground wire briefly. I didn't think too much of it but then my blower didn't work when I put it back together. I pulled it back apart and I don't have power to the hot wire anymore so I must have blown the fuse. Are there any fuses other than the ones in the box under the hood that might be my culprit? It's about to get very hot here.
