Where to mount schrader valve

[Mid_length]

I just installed airlift helper bags on my 07 suburban. Where is a good place to mount the schrader valves? Instructions suggested behind the fuel door or in the wheel wells. Just looking to see what others did thanks

 

[gooffeyguy]

On my 2001 I mounted the valve back by the receiver hitch on the bracket that holds the 7 pin trailer wiring plug. I only have 1 valve that T'd to both bags. Don't know if there's a place for something like that on the newer models.

 

[swathdiver]

I just installed airlift helper bags on my 07 suburban. Where is a good place to mount the schrader valves? Instructions suggested behind the fuel door or in the wheel wells. Just looking to see what others did thanks

In my previous vehicles and in the Yukon someday, they get mounted to the bumper (cover in this case), facing down to the left of the hitch, halfway between it and the end of the bumper. Easy access from the left side away from the exhaust.

 

[97YukonNZ]

I dont know about the newer models but my license plate mounts to the bumper.
I would bust a hole im my plate if running air and mount the valve through that. Easy access and out of the way.

 

[Doubeleive]

on my silverado one of the license plate bolt holes is the schrader valve, mine has a onboard pump but the port is there for external inflation if the pump fails.

 

[Mid_length]

Plate on mine is mounted to the back hatch. I think I’ll take swathdivers route. Thanks for the replies!