What did you do to your NBS GMT800 Tahoe/Yukon Today?

strutaeng said:

I tried my luck on body work last weekend. I had these horrible deep scratches at the bottom of my 06 Suburban door and a nasty dent near the handle. I took off the door, did body filler, primer, base and clear.

I had to go but one of those 3M wheels to remove the adhesive from the door trim.

It came out a little orange-peel on the clear, but decent. I used the mid-grade HVLP HF gun for everything. I was supposed to another HTE gun I have for the clear only as it atomizer better, but didn't feel like getting another gun dirty. It's certainly better than before...

Click to expand...

strutaeng said:

I tried my luck on body work last weekend. I had these horrible deep scratches at the bottom of my 06 Suburban door and a nasty dent near the handle. I took off the door, did body filler, primer, base and clear.

I had to go buy one of those 3M wheels to remove the adhesive from the door trim.

It came out a little orange-peel on the clear, but decent. I used the mid-grade HVLP HF gun for everything. I was supposed to another HTE gun I have for the clear only as it atomizer better, but didn't feel like getting another gun dirty. It's certainly better than before...

Click to expand...

latvius said:

Yup cut and buff it will look like a mirror and put the rest of the truck to shame. Then you'll have to paint it all

Click to expand...

latvius said:

Glad it's going good so far hope that is a real step in narrowing the problem, just for my own sanity I found the fuse I was talking about it is in the alternate fuse box location (drivers side dash)

Click to expand...

project_x said:

I finished my interior upgrade
Added Denali Wood grain dash bezel and console (after painting the beat up gray).
View attachment 436852View attachment 436853
New Seat Bottom cover.
View attachment 436854
Remove carpet and cleaned it.
Put down Kilmat sound deadener on the floor.
View attachment 436855

Click to expand...

S33k3r said:

Thanks! She tried to drive it to work, Friday last week, and she got "reduced engine power" again. I did get a reader on it, and the knock sensor circuit has low voltage on it. So I think there's a parasitic draw, somewhere -- likely a corroded and/or partially broken wire.

Click to expand...