You can use Goo Gone/adhesive remover product, Wd-40, Buffing compound, if it really on there you can use Decal Eraser Wheel. Can you PM me if you have the controller box, and the lights for the Outer Edge kit.
I posted here about it I don't have access to Gm at this time for RPO codes but you can take a photo of the glovebox Plate and decode it online
https://www.tahoeyukonforum.com/threads/2014-ppv-suspension.128307/#post-1595736
07 Yukon Denali w/stock 6.2L L92 w/195k miles. No DIC or CEL. It runs great.
When I ordered my pump from the dealer did not notice until I dropped the tank it did not have a level sensor something to check.
Depends on what part of the US you are in might want to order a Locking tank ring and...
Sounds like a awesome project. When I leave my current state wanted to take a 2500HD chassis and cut off X feet off the back move the axle forward.
Hope to find one with a Duramax or swap a Cummins engine. Would be awesome to see a Tahoe 2500HD.
I mean it would not be to hard to add some leaf...
I don't want to deal with something I cant smog, or visiting a Referee every other day with "Fixes", Went to a local college with a Ref on site and seeing the same 8 people coming back for "Smog Tech" got the serial engine number was wrong, wrong manual transmission was down to gear ratio, One...
my main reason for the conversion is more power LMG HP:310 Tq:335 L94 HP:403 Tq:417.
block LMG Cast Iron L94 is Aluminum from a lot of spec checking there is some good and bad with this swap.
For now looking at options when the LMG dies can I put a L94 or put a rebuild LMG back in.
If I go...
I have a 2013 Tahoe SSV the 5.3 LMG is on it way out. Was looking at swapping to the L94 6.2 but keep the DOD and AMF due to living in California.
Question would it be a plug and play deal I can keep the LMG 5.3 tune factory tune and run the L94 6.2 engine and pass emission testing, Then once...
I like to use Valvemedic the Gray bottle every 2nd oil change. Worked great for for lifter noise, fixed a couple DOD lifters on this product.
https://motormedic.com/products/motor-medic%C2%AE-valve-medic-oil-detergent-12oz
Here is a post I made about this subject with parts number and RPO codes - Might bug a admin to make a Pin on this
https://www.tahoeyukonforum.com/threads/adding-power-folding-mirrors.123610/#post-1634483
From what research it was more common on baseline Silverado, on mine I bought a Abs plastic sheet and cut it to fit then used small square of plastic on the sides to hold it.
Examples:
https://www.ebay.com/itm/256033048044
https://www.ebay.com/itm/126047730429...
On my roommates 14 Chevy Caprice we put Chevy SS mufflers on it we swapped the electric cut out for Vacuumed ones. Also the trick on the Pump is to get it from Autozone or O'Reilly Auto Parts they come with a lifetime warranty.
The post where I got the information from...
Amazon specials only set I can find that where no H1 on both and made it look a little modern - the original set water got inside when the department removed the lights and did not cover the holes front and back. I used RV clear silicone on the tops of the lights and have not had any issues.
I have towed a couple things with my SSV, Read the posts on trailer brake wiring all the wiring is there just need to buy a brake controller and pigtail.
Link on wires under the hood and harness.
https://chevroletforum.com/forum/silverado-fullsize-pick-ups-21/factory-brake-controller-diy-55257/
Here is the part number if anyone wants to order it
9L7 Up fitter Kit Black Part Number - 84942073
Harness Instrument Panel Auxiliary Block Part number - 84497098
Battery Extension Cable Harness Harness Part Number - 84794790
Fuse Kit Part Number - 84669070
Black Switch Part number - 84688687...
All that Trim pops off super easy unless someone used self tappers, My guess all those wires runs to the back area or up the A pillars to the roof for lights and etc.
I seen your post in the PPV section I would look at a Test light easier to use for now, If you have a little money and want to get a decent tool look into a Power probe type tool.
With a test light you can go basic with a bulb, or they sell them with screen that tells you the voltage, Power...
I have a 09 Yukon XL (gmt900) was thinking about ditching the clutch fan but cant find a decent kit or write up that dose not involve reprogramming something after or having to new temp switch, or something you stick in the radiator. I noticed it sounds like a jet engine in the morning until the...
You found one of my old post, it is a direct fit our center dash sticks out more then the truck model see attached photo it is more common for a Jump seat then a full console in a truck and a SUV (attacked both consoles), you will need to cut the airbag cover a little sometimes they bolt in fine...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.