2007 yukon denali oil leak

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

bangon

TYF Newbie
Joined
Feb 20, 2024
Posts
9
Reaction score
3
Have an oul leak on my 2007 yukon denali. Changed oil pan gasket still leaking. It's not rear seal. That dry as a bone in there. It's on both sides at rear of motor. You can see it on the starter bokts on one side. Any ideas?1000005003.jpg
 

Attachments

  • 20240723_151227.jpg
    20240723_151227.jpg
    228.5 KB · Views: 5
  • 20240723_151222.jpg
    20240723_151222.jpg
    296.1 KB · Views: 6

strutaeng

Full Access Member
Joined
Aug 10, 2023
Posts
1,178
Reaction score
2,445
Location
Dallas, Texas
Clean up the area real good and put some dye in the oil.

The rear main seal is always tricky. When mine leaked the area behind the flex plate holes looked pretty dry. It was not until I added the dye, that I was able to see with black light, right at the right spot under the crank pulley (6 o'clock) I could see the drip.

Ditto on addition RTV on the oil pan gasket corners.

The oil cooler lines or block-off plate is another good place to check.
 
OP
OP
B

bangon

TYF Newbie
Joined
Feb 20, 2024
Posts
9
Reaction score
3
It's probably the rear housing plate gasket that holds the RMS. It'll leak higher up and drain down. Lived with mine for 40k, then pulled the trans and replaced the cover. The seal was dry, the cover gasket gets stiff and compressed.
Pretty much what I think too. Thank you
 

Geotrash

Dave
Supporting Member
Joined
Feb 16, 2018
Posts
6,426
Reaction score
15,922
Location
Richmond, VA
Check the valley plate bolts for tightness too - at least the ones you can reach. We've seen that gasket take a set too, and leak because the bolts no longer have anything to press against.
 

Airman68

Member
Joined
Jul 26, 2022
Posts
88
Reaction score
156
Location
Kaukauna, WI
It's probably the rear housing plate gasket that holds the RMS. It'll leak higher up and drain down. Lived with mine for 40k, then pulled the trans and replaced the cover. The seal was dry, the cover gasket gets stiff and compressed.
Is this on all engine versions? I have a 5.3. I have had a mystery oil leak for a long time. Mosly just irritating since I cant find it. I did have valve covers leaking a bit which was some of it and the block off plate too.
 

donjetman

Full Access Member
Joined
Oct 22, 2018
Posts
1,531
Reaction score
2,714
I recently had the intake manifold off on our 07 6.2 Denali w/197k miles and all valley cover bolts were tight.
DSCN8451.JPG
 
Last edited:

Forum statistics

Threads
132,311
Posts
1,865,742
Members
96,899
Latest member
mohd33303
Top