2014 supercharged 5.3 14 Tahoe

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

94ISS

TYF Newbie
Joined
Jul 20, 2021
Posts
3
Reaction score
0
I have an engine light that no one seems to be able to figure out. I added a supercharger to it, otherwise stock. Customer service from Whipple wasn’t much help either.
 

Attachments

  • 049DC53D-D56D-4073-9A91-427543CF4F8C.jpeg
    049DC53D-D56D-4073-9A91-427543CF4F8C.jpeg
    364.6 KB · Views: 15
  • A7E27300-92D8-4AEC-B9A2-0801B9A2B380.jpeg
    A7E27300-92D8-4AEC-B9A2-0801B9A2B380.jpeg
    490.7 KB · Views: 14

iamdub

Full Access Member
Joined
Apr 23, 2016
Posts
20,821
Reaction score
44,945
Location
Li'l Weezyana
I have an engine light that no one seems to be able to figure out. I added a supercharger to it, otherwise stock. Customer service from Whipple wasn’t much help either.

That's an odd one. I'd start by swapping sides with the upstream O2 sensors to see if it becomes a P219B.

If it stays on Bank 1, then you know it's not a funky sensor and something upstream is causing it. Possibly a lazy/leaky injector as it's a rich code.
 

gat0r

Full Access Member
Joined
Dec 11, 2015
Posts
3,107
Reaction score
5,831
Location
DFW
seems overly generic error code


  • Engine vacuum leak (large)
  • Defective oxygen sensor/s
  • Burnt, chafed, broken, or disconnected wiring and/or connectors
  • Engine exhaust leaks
  • A faulty mass air flow or manifold air pressure sensor
  • Bad fuel pump or clogged fuel filter

lots of hits on google
fixes are ALL over the place :-\
 

91RS

Full Access Member
Joined
Nov 15, 2009
Posts
2,588
Reaction score
2,033
Location
GA
Replace both pre-cat oxygen sensors to start. Use ONLY OEM sensors.
 

THarber

Full Access Member
Joined
Jun 4, 2021
Posts
307
Reaction score
277
You've got a vacuum leak somewhere and its causing the O2 sensor to send faulty adjustments to compensate. Check to make sure everything after the MAF is tight with no air leaks, check the pcv lines, throttle body gaskets, etc....
 

randeez

Full Access Member
Joined
Sep 29, 2017
Posts
7,444
Reaction score
23,679
Location
south florida
@Rocket Man was saying setting the top of the blower down onto the base and keeping oring in place is a pita
Could try the ol spray starter fluid around everything and see if idle changes
 
OP
OP
94ISS

94ISS

TYF Newbie
Joined
Jul 20, 2021
Posts
3
Reaction score
0
I used the injectors the SC came with. O2 sensors are new. MAF and MAP seem to be reading properly. I used vasoline on that o-ring(recommended). 2 mechanics think it has something to do with the tune…Whipple says otherwise. It ran perfectly before and still perfect after the upgrade. I’ll try some starting fluid and see what happens.

I’ll keep y’all posted.

SC is badass!
 

13UpInSmoke

Full Access Member
Joined
Jul 25, 2021
Posts
188
Reaction score
319
Id double check that oring, had it tear on me two different times when I would work on 2.9 whipple on a hemi
 

Tyrant

Member
Joined
Mar 19, 2022
Posts
71
Reaction score
40
Is the code always present? My '08 has a blower as well and it'll pop a similar code when I get a little too zealous off the line and the belt slips.

It really only happens when the right balance of traction control and throttle pressure hits; it's annoying, because it'll stay until I clear the code, then disappear until I make the same mistake again.
 
OP
OP
94ISS

94ISS

TYF Newbie
Joined
Jul 20, 2021
Posts
3
Reaction score
0
Is the code always present? My '08 has a blower as well and it'll pop a similar code when I get a little too zealous off the line and the belt slips.

It really only happens when the right balance of traction control and throttle pressure hits; it's annoying, because it'll stay until I clear the code, then disappear until I make the same mistake again.
It’s on all the time.
 

Forum statistics

Threads
132,376
Posts
1,866,999
Members
97,012
Latest member
Roscoe2352

Latest posts

Top