2020 Tahoe..Air Dam

[Phil Rosche]

I just bought a 2020 Tahoe with 4WD. The front air dam looks really NASCAR, it hangs down really low. I'm sure my offroading is less than 1% of my driving, but I do occasionally drive in the sand, snow, and mud.

I'm worried about how low the air dam is. It says something in the owners manual about taking it off if you anticipate getting it hit offroading.

Is there an aftermarket air dam that doesn't stick down so low?

What have other folks done?

Thank you

 

[wjburken]

I just bought a 2020 Tahoe with 4WD. The front air dam looks really NASCAR, it hangs down really low. I'm sure my offroading is less than 1% of my driving, but I do occasionally drive in the sand, snow, and mud.

I'm worried about how low the air dam is. It says something in the owners manual about taking it off if you anticipate getting it hit offroading.

Is there an aftermarket air dam that doesn't stick down so low?

What have other folks done?

Thank you

Welcome to the forum from Iowa.

One thing folks have done is trim some off of the bottom of the air dam. On older generations, they have also been able to find one off of a PPV version as they have been a little narrower.

 

[PG01]

https://www.tahoeyukonforum.com/thr...wer-valance-that-comes-on-police-model.90043/

 

[Phil Rosche]

How much shorter (less wide?) do you think it is than the one that came on the Tahoe?

 

[hcvone]

Mine makes a good snowplow being lowered in upstate NY, good thing the snow is like powder

 

[Da90]

I cut mine to where it’s straight across. I got the idea from here.



Sent from my iPhone using Tapatalk Pro

 

[juicedgsr95]

I cut mine as well. measured 3" down from where the lip starts and marked a line. Angle grinder with cut off tool and the whole thing from start to finish took less than 10 minutes.

 

[gat0r]

just drive it & if it gets rock rash, then trim it a bit.
saves the crazy $$ that GM wants for the PPV version for other mods

 

[72-droptop]

I cut mine as well. measured 3" down from where the lip starts and marked a line. Angle grinder with cut off tool and the whole thing from start to finish took less than 10 minutes.


View attachment 253891

that looks great. i trimmed my last one but not enough. i like the look of yours.

 

[akbrener]

Trimmed mine. 1.5” down then blended into the molded line of i recall.