Check out my new PPV build

[ChunkePPV]

I had to replace one of the taillights so I thought it was a good idea to upgrade, decisions are hard.

 

[ChunkePPV]

I narrowed it down to these two

 

[ChunkePPV]

And finally this is the one I went with!

 

[ChunkePPV]

I ordered the suspension kit that @RichardCranium recommended and 5 different headlight assemblies from alpharex, anzo, stock, and couple of odd balls and and will show you guys how they look, and maybe help me decide lol!

 

[Peacock]

Nice looking truck and I like those new front seats.
The Does it have a trailer receiver on the back and if it does is there a tow/haul switch ?

 

[Kee Fuller]

I’m assuming you’re going to wire the seats up cause they aren’t plug and play.

 

[ChunkePPV]

Thanks on the seats! It is definitely crazy owning a PPV, still not sure on whether I should keep the searchlight lol, but I will check on the tow switch @Peacock
And on the seat wiring, I didn't realize it wouldn't just plug in, but thats how it goes. I bought a 20 pin male/female molex harness and will attempt to wire it up. I've seen a video where a guy got the electrics to work. My hope is to get the seat heating and cooling working as well. Any ideas where to look for the vehicle schematics of the Escalade seats? @Kee Fuller

 

[ChunkePPV]

I've never seen a ppv with body side mouldings on it. Do you know if it was municipal/local govt? Maybe supervisor's?

I found out from the guys on the lot, that it was the sergeants vehicle and it mileaged out. So it went to the lot

 

[Sparksalot]

Trailer/tow switch is simple. Swap the gear lever. About $70, and takes 15 minutes.

 

[Sparksalot]

It looks like you have the curt hitch already. I did that too, but the ground clearance became an issue for how I use thecopcar. So I swapped the impact bar to get the factory location.