Dropped of the '17 Denali this morning to start the Maggie install

[08HoeCD]

My kinda mod thread!

 

[UATahoe]

Here are some quick photos from the work parking lot. Getting work done today was wishful thinking. Lol. Been a steady stream of coworkers walking out to check it out.

 

[CND17 BURBAN]

Wow that looks amazing. I wonder if I can convince the wife that this is a must have for my 17 Suburban.

 

[gat0r]

curious, what size pulley is on it?

& i like that H/E tank. that is different from other installs i have seen.

& mine is significantly smaller (prolly 1/2 that size)

 

[UATahoe]

The pulley is the stock magnuson pulley. Down the road I may up the boost some. The Moroso coolant tank turned out great!

 

[yates ™]

What dreams are made of. Bet it is fun to drive.

 

[gat0r]

i figured you'd start w/ stock pulley, was hoping you knew size. (or instructions would mention a p/n)
as i know they are a diff size than the 1900.

i want to say it may be either a 3.6" or 3.8" w/ the 2300 kit.
it should make about 6#'s boost w/ stock magnuson tune.


fyi w/ CAI & BBP tune, it could bump just over 7#


once your warranty runs out, there seem to be quite a few options

 

[UATahoe]

I looked through the manual but no mention of pulley size. I will throw a tape measure on it this evening. Oh definitely. Once the warranty period is gone, it will get some more love. LOL. I had a volant intake but got some feedback that it wouldnt work with the maggie. Is there a certain cold air box that does?

 

[08HoeCD]

Never really understood the idea of waiting until a warranty expires to do mods. Life is short, and I would never do any mods that I would fear would contribute to a failure anyway.

 

[UATahoe]

Just peace of mind. Plus the dealership guys told me that they would maintain my factory warranty as well as long as i stuck to the magnuson factory setup. Hard to beat or complain about that. Plus the truck only has 2800 miles on it so i know there will be some gremlins to work out.