Get a catch can before any mods.

[Chrismnj]

Does anyone know if the catchcans.com is baffled and filtered?

I know that Moroso has it

 

[XL04]

Thanks for the replies. I was looking at the mishimoto i like the design but it's a little expensive. This generic one looks the same however and is reasonably priced.
Everpert MMBCC-UNI Baffled Oil Catch Can Reservoir Tank Kit Performance Universal (Red) https://www.amazon.com/dp/B07J5D1CJY/ref=cm_sw_r_cp_apa_i_6tKyCbR1XJ3CE

 

[Sam Harris]

First oil change since installing my catch can. So about half an oil change interval, (1280 miles) I ended up with probably about 1.5oz. Really glad I found this forum, with all the knowledge and experience. [emoji106][emoji16]

Sent from my iPhone using TapaBlah

 

[Chrismnj]

First oil change since installing my catch can. So about half an oil change interval, (1280 miles) I ended up with probably about 1.5oz. Really glad I found this forum, with all the knowledge and experience. [emoji106][emoji16]

Sent from my iPhone using TapaBlah

Nice red catch can, I usually find some alcohol in them, lol,

 

[Sam Harris]

Nice red catch can, I usually find some alcohol in them, lol,

Hehe. I usually use glasses for the scotch. [emoji16][emoji1634]

But the catch can is also red..

Sent from my iPhone using TapaBlah

 

[donjetman]

Hehe. I usually use glasses for the scotch. [emoji16][emoji1634]

But the catch can is also red..

Sent from my iPhone using TapaBlah

I'm running a engine oil bypass filtration system. Im planning to go till it reads 0%(7500 miles ?) before changing my oil, but I'll let used oil analysis indicate when it needs changing. Here is what I had in my catch can after 1200 miles of fast hwy driving.

View media item 27505

 

[Sam Harris]

I'm running a engine oil bypass filtration system. Im planning to go till it reads 0%(7500 miles ?) before changing my oil, but I'll let used oil analysis indicate when it needs changing. Here is what I had in my catch can after 1200 miles of fast hwy driving.

View media item 27505

I can’t see your picture.


Sent from my iPhone using TapaBlah

 

[iamdub]

I find that high RPM and repeated heavy loads, such as heavy accelerating, drastically increase the amount of oil in the PCV system.

 

[randeez]

alright catch can experts....
need a one for my truck - driverside goes to top of manifold, passenger side goes(went) to intake tube.

ive read you should have two separate cans for these systems, why should i not plumb them into a single 3 port can? not sure where to pull vacuum line - could go into intake tube pre-turbo (nearly constant vacuum) or back into the top of the manifold I would just need to use a check valve (vacuum when not in boost)

 

[HiHoeSilver]

alright catch can experts....
need a one for my truck - driverside goes to top of manifold, passenger side goes(went) to intake tube.

ive read you should have two separate cans for these systems, why should i not plumb them into a single 3 port can? not sure where to pull vacuum line - could go into intake tube pre-turbo (nearly constant vacuum) or back into the top of the manifold I would just need to use a check valve (vacuum when not in boost)

I've never seen the point of grabbing the passenger side. It's just clean air over there.

@iamdub had a lovely explanation of this the other day.

Edit: link to said post

https://www.tahoeyukonforum.com/thr...ahoe-yukon-today.44151/page-1376#post-1321363