Growing up doesn't have to suck

[iamdub]

I'm getting the itch to swap my struts back under the arms again to get another 2" of drop. This shit is addicting. Damn you people. Which also means the rear will have to go lower at some point as well.

It's summer. Do it. Don't be a bítch.

Ease into it by undermounting without the spacer first and take precise B/A measurements after a settling drive.

 

[iamdub]

I'm in the same boat but unless I see drips, like you, I'll let it ride.

I've already forgotten about it. lol

Been seeing a girl 90 miles away and haven't had the ol' Hippo off the road long enough to dismantle her. Of course, now that I'm looking at the driveshaft area, I'm tempted to have that custom aluminum one made up.

 

[randeez]

I've already forgotten about it. lol

Been seeing a girl 90 miles away and haven't had the ol' Hippo off the road long enough to dismantle her. Of course, now that I'm looking at the driveshaft area, I'm tempted to have that custom aluminum one made up.

90 miles is a long way to think about if its worth it

 

[iamdub]

90 miles is a long way to think about if its worth it

I'm driving 90 miles to see a chick. Clearly, a driveshaft is NOT what's on my mind.

 

[89Suburban]

I'm driving 90 miles to see a chick. Clearly, a driveshaft is NOT what's on my mind.

But a shaft is.

 

[OR VietVet]

It was just as I found it. No drips. But, I don't expect it to get better.

Yep, will never get better.

 

[randeez]

But a shaft is.

"dont worry lil buddy, we're almost there"

 

[KidWgn]

I'm driving 90 miles to see a chick. Clearly, a driveshaft is NOT what's on my mind.

Contrary.

You're driving to shaft.

 

[opfor2]

Since the factory insulator is kinda pathetic and mine is always falling in, I decided to replace it with something taller, wider and a little denser:

View attachment 248949


I hot-glued it into position:

View attachment 248950

...And test-fit it against the fender. Nice and tight seal that shouldn't fall out of place:

View attachment 248951


Compared to the factory seal:

View attachment 248952

Where did you buy the foam insulator?

 

[89Suburban]

Where did you buy the foam insulator?

Search Results for air condition foam at The Home Depot

Search Results for air condition foam at The Home Depot

www.homedepot.com