Hellpppp wilwood install
- Thread starter 06xl
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
chauncey0337
Full Access Member
Bleed the brakes properly? Make sure enough brake fluid?
- Joined
- Jan 3, 2011
- Posts
- 50,409
- Reaction score
- 17,414
Low brake fluid or air in the lines will give you that message...
I've bled the brakes 3 times started with rear right and the reservoir was full each time. Also is it possible that when I suck the old fluid out the reservoir an filled up with new fluid then bled the brakes may have caused this?? I've noticed the new fluid coming out when bleeding so I know it's passing thru the system I didn't unplug any wires at all simple brake rotor,pad change and stainless hose change nothing special at all.
One thing I forgot to mention while I was putting the tires back on I had to lower the jack a bit and i over turned the jack handle and the spare tire laid flat on the jack with the rotors an inch off the ground and the front on j.stands I had to use another jack to bring the truck back up so I can pump the jack up that was stuck under the spare. Do you guys think this awkward level will throw the sensors on???
Sounds like it is an issue with your fluid levels. You may need to do it all over again.
Bled again?? If so I did 2 times after the issue. Brakes work fine though
Leave the battery disconnected for 15mins? Or just get the codes cleared at an Autoparts store.
Well I tried the batt but not for 15min also Jenna do you remember awhile back I had this problem with the stability control disability light? For those who don't know It was raining for days in my area an I decide to drive my nali an out of know where my service stability light came on I took it to the dealer and there cleared it for $110 
. I don't think the auto store has anything to clear codes unless it's a check engine code. The brakes work fine though except I get this weird shaking /vibration when coming to a complete stop but I think it's the pads rotors breaking in
. I don't think the auto store has anything to clear codes unless it's a check engine code. The brakes work fine though except I get this weird shaking /vibration when coming to a complete stop but I think it's the pads rotors breaking in
What did the dealership say it was when they cleared it? It should not have cost $110 to just clear a code!!
Similar threads
