I finally finished up and installed the passenger side floorpan with screws and some 3m body seam adhesive. Unfortunately the pan is not as nice looking as I wanted it to be sense I ran out of money for painting it red and only have a few coats of the greenish gray primer on top of the black rust proof coat it comes with from the manufacture. I ended up smearing the seam sealer with my fingers around the pan because the pan was in a very tight spot and I don't have a proper gun for it. It is messy if you lift the carpet and look but it could be worse I guess. I mean it will be completely covered by the padding and carpet so its not an eyesore. I just really needed to get this done asap before the temps drop and its going well below freezing already this weekend. So I need my truck. But I know the rust has been slowed to almost a stop and my paint job adhered quiet well. May just put down some bed liner on that pan before I button the truck up again. Who knows maybe I'll have it welded properly in the future but for now it won't rust it holds well and is well sealed. I will get some pics up tommorow.
