This guy shows the stub axle going in without the circlip on it. Must be inside already.
Inner axle shaft fixin
- Thread starter Jobi-Wan Kenobi
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
OP
OP
Jobi-Wan Kenobi
Full Access Member
- Joined
- Aug 27, 2022
- Posts
- 207
- Reaction score
- 293
Just a thought. What's the likelihood of pulling the shaft out, removing the cir clip, putting the cir clip in the shaft bore and then using the shaft to push the cir clip into place? Theoretically it would avoid me having to drop the axle and split it.
OP
OP
Jobi-Wan Kenobi
Full Access Member
- Joined
- Aug 27, 2022
- Posts
- 207
- Reaction score
- 293
@Fless i believe so. I watched another video earlier and saw the same.
Same here:
What's the method or tool for inserting the circlip? Not surprised that Haynes doesn't cover this part.
Last edited:
When you remove it according to the instructions the circlip stays in the housing, correct? If so, there’s the answer.
OP
OP
Jobi-Wan Kenobi
Full Access Member
- Joined
- Aug 27, 2022
- Posts
- 207
- Reaction score
- 293
@Rocket Man that's what I'm gathering.
OP
OP
Jobi-Wan Kenobi
Full Access Member
- Joined
- Aug 27, 2022
- Posts
- 207
- Reaction score
- 293
I've never split a front axle assembly before. In the event that the idea i have above doesn't work is it worth going through splitting this one to put a new cir clip in or should I just swap in another one?
Absolutely 100 percent the proof is in the video!!!! GD what a stressful thread LOL!!! The answer is apparent now. You did nothing wrong, the clip is supposed to stay in there like it did. and you should be able to install that shaft by hand no problem and it pop into place. Just get the clip safely back in where it is supposed to be and button this thing up! Maybe you can get the clip started in the splined hub and use a dowel or something to carefully slide into place.
George B
¯\_(ツ)_/¯
Also…. The answer is contained within!
www.tahoeyukonforum.com
Front differential rebuild GM 8.25 IFS (needs to be a sticky)
While searching how to rebuild the front diff on my Yukon I ran into this thread that I think should be a stick on this site. Its a very detail DIY, the only thing that I would add to this DIY is to replace the side gear washers and the spider gear washers on the carrier since you are already...
www.tahoeyukonforum.com
