Issues after oil change, tranny flush, diff fluid change, and all brakes...

[GranPrix]

So today I dropped the oil plan for a cleaning and oil change, dropped the trans pan and flushed it along with a new filter, changed the diff fluid along with a cover cleaning and changed all four rotors and pads. Now I have the check engine light on, the traction control light on and it's also telling me the stabilitrac and traction control is not working.

Now after I did all this maintenance I'll be driving anywhere between 0-60 mph and my revs will slightly jump and drop back down, a small acceleration on it's own.

In addition to this about a month and a half ago I cleaned out my TB and to this date the relearn process has yielded negative results. I still get a small surge of power as I come to a stop.

http://www.tahoeyukonforum.com/threads/idle-relearn-throttle-body-cleaning.99423/#post-1195435

 

[swathdiver]

I reckon you knocked a speed sensor off kilter when you were working on the rear rotors. They are attached to the backing plate, check them out. What codes are you getting?

 

[Doubeleive]

could be a ABS sensor, check all your work, make sure you didn't yank a sensor wire out, do you have a scanner that does ABS?, if so run a scan and see what sensor is out

 

[GranPrix]

I’m putting it on a scanner tmrw and see what’s codes I get and check the sensors

 

[GranPrix]

So I ran the scan on it,

P0102:
Mass or Volume Air Flow Circuit Low Input

P0113:
Intake Air Temperature Circuit High Input

Cleared them and we're good now. I just remembered I removed the intake tube to flush the trans hence the codes!

But I still have the stabilitrac and traction control going off

 

[swathdiver]

So what are the codes for the brake system?

 

[GranPrix]

WOW I’m an *******, I never reconnected the MAF plug. Now the stabilitrac and traction control warnings are gone but the check engine light is still on.

Now here’s where it gets interesting. With the codes cleared and the plug unplugged the power surges were gone. Now that the plug is back in I’m getting the small power surge again

 

[HiHoeSilver]

WOW I’m an *******, I never reconnected the MAF plug. Now the stabilitrac and traction control warnings are gone but the check engine light is still on.

Now here’s where it gets interesting. With the codes cleared and the plug unplugged the power surges were gone. Now that the plug is back in I’m getting the small power surge again

Did you clean the MAF with something?

 

[GranPrix]

So what are the codes for the brake system?

I never had any brake codes or issues

 

[GranPrix]

Did you clean the MAF with something?

Back on 1/12 I sprayed the MAF with MAF cleaner