Zed 71
Full Access Member
That looks good.
No more woodgrain--AND NOT PAINT
- Thread starter Sweet_N_Low
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Looks really good man! I actually contemplated that once.. Dont worry, that wont discolor. Real CF will discolor if the proper resin isnt used. And it most instances those are exterior pieces.. 3M di noc is good stuff and wont fade at all. Man, how did you pop off those pieces.. I tried for the life of me to get the a/c ones and the stereo ones off and had no luck! I only ended up getting to door ones off. Any advice?? Do you just need to pry harder. Crap looked like it was gonna break though:?
OP
OP
Sweet_N_Low
Full Access Member
- Joined
- Mar 11, 2011
- Posts
- 373
- Reaction score
- 0
When you get a little leverage look behind to where the clips are and try to get your hands as close to the clips as possible, give it a quick jerk, see if that works
Quikzilver
TYF Newbie
Yes, I did use the 3M vinyl. But 5% window tint should help you out. My SS is tinted in the rear only, so hopefully it will hold up better for you!! Again, looks really great!!
Keanen55
Full Access Member
That looks good!! I'm going mine this weekend!!
dropahoe
TYF Newbie
What is the material called (please don't say carbon fiber lol) do I just search for 3m vinyl?
Last edited:
OP
OP
Sweet_N_Low
Full Access Member
- Joined
- Mar 11, 2011
- Posts
- 373
- Reaction score
- 0
It is 3M di noc, it's all over eBay. 12x60 piece did everything I did with some extra and it was $31
- Joined
- Jan 3, 2011
- Posts
- 50,348
- Reaction score
- 17,134
OP
OP
Sweet_N_Low
Full Access Member
- Joined
- Mar 11, 2011
- Posts
- 373
- Reaction score
- 0
That is cheap!!
Yup. $31, 3 hours, a 6 pack of Magic Hat #9, vwalla
- Joined
- Jan 3, 2011
- Posts
- 50,348
- Reaction score
- 17,134
How are the trim pieces held in? Is it just by tabs and you just "pry" them out?
