[noise] drive shaft rubbing? - SOLVED

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

OP
OP
S

seatown

Member
Joined
Oct 18, 2018
Posts
44
Reaction score
35
Seems to be tied to the speed of the drive shaft.
Was under there last night , joints felt pretty tight, shaft spun cleanly. Didn’t see any clear rubbing though
 

Geotrash

Dave
Supporting Member
Joined
Feb 16, 2018
Posts
6,423
Reaction score
15,916
Location
Richmond, VA
Seems to be tied to the speed of the drive shaft.
Was under there last night , joints felt pretty tight, shaft spun cleanly. Didn’t see any clear rubbing though
Sounds like either the starter or a cracked flex plate. A pretty common issue on these is the starter drive gear return spring fails and lets the gear bump against the ring gear on the flywheel. It's particularly noticeable under acceleration. Similar thread: https://www.tahoeyukonforum.com/threads/5-3-engine-tick-only-in-drive-reverse.148182/
 
OP
OP
S

seatown

Member
Joined
Oct 18, 2018
Posts
44
Reaction score
35
Sounds like either the starter or a cracked flex plate. A pretty common issue on these is the starter drive gear return spring fails and lets the gear bump against the ring gear on the flywheel. It's particularly noticeable under acceleration. Similar thread: https://www.tahoeyukonforum.com/threads/5-3-engine-tick-only-in-drive-reverse.148182/
Interesting
A little bit different noise, but same reaction to acceleration.

Before I replace the starter is there a way to confirm ?
 

Geotrash

Dave
Supporting Member
Joined
Feb 16, 2018
Posts
6,423
Reaction score
15,916
Location
Richmond, VA
Interesting
A little bit different noise, but same reaction to acceleration.

Before I replace the starter is there a way to confirm ?
Yes, but it requires removing the starter and holding it gear end down to see if the drive gear falls down to the end of the shaft. But, if your starter is original, it's not the worst thing in the world to replace it with a new one anyway. Eventually it *is* going to fail, so it's one less thing to worry about.
 
OP
OP
S

seatown

Member
Joined
Oct 18, 2018
Posts
44
Reaction score
35
Yes, but it requires removing the starter and holding it gear end down to see if the drive gear falls down to the end of the shaft. But, if your starter is original, it's not the worst thing in the world to replace it with a new one anyway. Eventually it *is* going to fail, so it's one less thing to worry about.
 

Forum statistics

Threads
132,300
Posts
1,865,591
Members
96,885
Latest member
BinOdhaib
Top