Okay, new problem, the engine is overheating

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Rummel6

Member
Joined
Mar 11, 2020
Posts
53
Reaction score
25
I have a 2011 Tahoe LS with 195k miles on it and it has a new water pump, thermostat, expansion tank, and replaced hoses at firewall. The issue I’m having is that when I pass someone at high rpms, the engine starts to overheat. I have to pull over, shut the engine off, and wait a few minutes. Also, when this happens, I have no heat. Please help because I can’t figure out this problem.
 

Tonyv__

Full Access Member
Joined
Apr 18, 2018
Posts
3,367
Reaction score
7,519
Location
Bucks county PA
If you have no heat. Also assuming your heater core isn’t clogged. You may be low on antifreeze. After replacing all those parts. You have to continuously check your tank to make sure all the air pockets have been filled and that it’s topped off
 

drakon543

Full Access Member
Joined
Feb 15, 2016
Posts
2,473
Reaction score
1,714
you may have a pocket of trapped air. at low rpms the flow is low enough to get around the trapped air. at higher flow it will compress the air and cause a blockage. you can either keep driving it at lower rpms and hope it works it way out and top the system off as needed as suggested above. your other choice is to drain the system back down atleast halfway approximately water pump level. then start the truck and as the truck is running slowly refill the coolant system until its topped off.
 
OP
OP
Rummel6

Rummel6

Member
Joined
Mar 11, 2020
Posts
53
Reaction score
25
I have done both I’m thinking honestly I may be over spinning the water pump and causing the belt to slip since I have replaced everything on the front of the motor
 
OP
OP
Rummel6

Rummel6

Member
Joined
Mar 11, 2020
Posts
53
Reaction score
25
My brother seems to think it may be running lean also but not sure on that because figured it would kick a lean code
 

bill1013

Full Access Member
Joined
Jul 7, 2020
Posts
448
Reaction score
961
Location
Waianae, Hawaii
Check the tension on the serpentine belt as it may be slipping. Also, old belts get hardened and slick, so they work okay a lower RPM but lose it when you get on it. You may just need to change out the belt.
 

OR VietVet

Multnomah Falls
Supporting Member
Military
Joined
Oct 8, 2014
Posts
20,636
Reaction score
36,242
Location
Willamette Valley
How clogged up is the air flow thru your radiator? I agree though that sounds like low on coolant from air pocket(s). Does the thermostat have the little weep hole in it?
 
OP
OP
Rummel6

Rummel6

Member
Joined
Mar 11, 2020
Posts
53
Reaction score
25
Tensioner is tight and I’ve topped it off a couple times and the radiator I would think is clogged I kee this thing clean
 

wsteele

Full Access Member
Joined
Dec 26, 2020
Posts
1,731
Reaction score
2,350
Did the symptoms start after you replaced all the water pump, hoses, etc., or was that why you replaced all that stuff?
 
OP
OP
Rummel6

Rummel6

Member
Joined
Mar 11, 2020
Posts
53
Reaction score
25
No it just started happening I replaced all those parts because the engine was squeaking but ended up being the cam needed replaced from that stupid afm so I did the full delete everything g has been fine for the last 8 months
 

Forum statistics

Threads
132,087
Posts
1,862,132
Members
96,552
Latest member
charles454

Latest posts

Top