Practical repurpose of second battery ?

[PPV_2018]

I was looking for some advice or ideas on what could I do with the second battery on a Tahoe PPV. Does anyone know what relays/modules are routed to the secondary battery (if any) from the factory?

I figure its intended use from the factory would be for upfitting, to power emergency equipment without drawing on the main battery but obviously in the civilian sector that isn’t really needed. So I’m wondering what should I do with it

Thinking about maybe doing a sound system, like amps and subs and wire it to the second battery?

What about setting it up as a ‘reserve’ battery in case the main battery fails.. Would that be possible? practical?

Would appreciate any input

 

[Sparksalot]

I was looking for some advice or ideas on what could I do with the second battery on a Tahoe PPV. Does anyone know what relays/modules are routed to the secondary battery (if any) from the factory?

I figure its intended use from the factory would be for upfitting, to power emergency equipment without drawing on the main battery but obviously in the civilian sector that isn’t really needed. So I’m wondering what should I do with it

Thinking about maybe doing a sound system, like amps and subs and wire it to the second battery?

What about setting it up as a ‘reserve’ battery in case the main battery fails.. Would that be possible? practical?

Would appreciate any input

You might look through the GM Upfitter guide to see if they were available with the isolation relay, and what the number is for it. In the gmt900 PPVs they were available with and without the relay. Thecopcar didn’t have one while theothertwin did. If I remember it was a common multipurpose relay used in a lot of GM vehicles. It had ignition sense to isolate the second battery when the engine was off.

 

[Doubeleive]

I was looking for some advice or ideas on what could I do with the second battery on a Tahoe PPV. Does anyone know what relays/modules are routed to the secondary battery (if any) from the factory?

I figure its intended use from the factory would be for upfitting, to power emergency equipment without drawing on the main battery but obviously in the civilian sector that isn’t really needed. So I’m wondering what should I do with it

Thinking about maybe doing a sound system, like amps and subs and wire it to the second battery?

What about setting it up as a ‘reserve’ battery in case the main battery fails.. Would that be possible? practical?

Would appreciate any input

commonly they are just connected in parallel

 

[justchecking]

Mine is set up so the primary passenger side battery is used for every thing. The second drivers side battery is only used for starting if the primary is dead. There is an isolation module that connects both only when engine is running for charging. If I need to start from the secondary battery I toggle a switch. Look up Hellroaring battery systems.

 

[PPV_2018]

You might look through the GM Upfitter guide to see if they were available with the isolation relay, and what the number is for it. In the gmt900 PPVs they were available with and without the relay. Thecopcar didn’t have one while theothertwin did. If I remember it was a common multipurpose relay used in a lot of GM vehicles. It had ignition sense to isolate the second battery when the engine was off.

Smart, I didn’t think to look through the upfitter guide. I skimmed through the guide and the only mention of anything isolation is this little bit when mentioning l electrical equipment:

“Isolated, Auxiliary 730 CCA, 70 amp-hour battery without battery run-down
protection for customer installed equipment. “

So then this means an isolation relay is in place, right? Or ..

commonly they are just connected in parallel

I guess that means wiring a sound system to the aux battery would be pointless, lol.

Mine is set up so the primary passenger side battery is used for every thing. The second drivers side battery is only used for starting if the primary is dead. There is an isolation module that connects both only when engine is running for charging. If I need to start from the secondary battery I toggle a switch. Look up Hellroaring battery systems.

Nice

Question. The isolator switch allows the battery to accept charge while the engine is running, but produces no output unless the switch is flipped, yes? Would the aux then act as the primary battery until you could replace the main or would you still have to switch it back over to the main for normal driving

Would you care to elaborate any further on your set up

 

[Doubeleive]

Smart, I didn’t think to look through the upfitter guide. I skimmed through the guide and the only mention of anything isolation is this little bit when mentioning l electrical equipment:

“Isolated, Auxiliary 730 CCA, 70 amp-hour battery without battery run-down
protection for customer installed equipment. “

So then this means an isolation relay is in place, right? Or ..

I guess that means wiring a sound system to the aux battery would be pointless, lol.


Nice

Question. The isolator switch allows the battery to accept charge while the engine is running, but produces no output unless the switch is flipped, yes? Would the aux then act as the primary battery until you could replace the main or would you still have to switch it back over to the main for normal driving

Would you care to elaborate any further on your set up

unless the primary battery is flat out bad (will not hold any charge at all) then you would only use the auxiliary battery to start it
the general rule of thumb is to use 2 new battery's of the exact same size type and age, so the chances of one just going bad out of the blue are slim
I just replaced both of mine yesterday at almost 5 years old

 

[justchecking]

Smart, I didn’t think to look through the upfitter guide. I skimmed through the guide and the only mention of anything isolation is this little bit when mentioning l electrical equipment:

“Isolated, Auxiliary 730 CCA, 70 amp-hour battery without battery run-down
protection for customer installed equipment. “

So then this means an isolation relay is in place, right? Or ..

I guess that means wiring a sound system to the aux battery would be pointless, lol.


Nice

Question. The isolator switch allows the battery to accept charge while the engine is running, but produces no output unless the switch is flipped, yes? Would the aux then act as the primary battery until you could replace the main or would you still have to switch it back over to the main for normal driving

Would you care to elaborate any further on your set up

Yes the aux would act as the main but if the main is really really bad it could pull down the aux over time. When my main went bad this summer on the 2011 I just flipped the switch to start for three days while AutoZone decided the old main was bad. It was under warranty and they kept testing it before that finally replaced it for free.
The switch could be placed in the cab but I just leave mine under the hood.

 

[PPV_2018]

Yes the aux would act as the main but if the main is really really bad it could pull down the aux over time. When my main went bad this summer on the 2011 I just flipped the switch to start for three days while AutoZone decided the old main was bad. It was under warranty and they kept testing it before that finally replaced it for free.
The switch could be placed in the cab but I just leave mine under the hood.

Nice

This is definitely on my to-do list