Love the part of the description that says "easy to operate." LOL
Re-covering wire loom
- Thread starter 992dr
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Love the part of the description that says "easy to operate." LOL
How about where it says it has a “certain isolation minus sound effects”.
akbrener
Full Access Member
I got my plastic loom from harbor freight, it actually had a pretty tight "split" and I just cut it a bit long.
iamdub
Full Access Member
How long has it been on?
akbrener
Full Access Member
About 8 months, so far so good. My factory stuff was almost non existent, didn't use much tape, only a little bit on the areas where small stuff T'd off larger runs.
OP
OP
992dr
Full Access Member
Do you have a link?
I'm worried about using any type of plastic due to the heat and how brittle the factory loom just disintegrates now.
What would you guys think is too much?
Not sure if these are LS specific though.
Found this for $125
https://www.psiconversion.com/products/accessories/extras/BRD-1001.html
And this for $106 from Painless
https://www.ebay.com/p/235462614?ii...MIuM-J7N-S5gIVCBgMCh2_fgMvEAQYAyABEgIu9vD_BwE
You can get the braided for anywhere from .17 a foot for 1/4” to $1.25 a foot for 1 1/4” so imo that’s a lot for the lengths they provide. But it does save hassle of figuring out what to buy. You can go to www.cableorganizer.com and add the same stuff to your basket to compare.
akbrener
Full Access Member
they have 1/4, 3/8, and 1/2"...
https://www.harborfreight.com/1-4-quarter-inch-x-14-ft-protective-wire-wrap-66985.html
https://www.harborfreight.com/1-4-quarter-inch-x-14-ft-protective-wire-wrap-66985.html
Similar threads
