Show off your 2015+ leveled Tahoes and Yukons!

[SSpinball]

Mcgaughys 2" level kit in the rear, Tahoe 2017
rides smooth as silk now, before it was a chuck wagon.

 

[MikeK1981]

I ordered new cutoff discs on Amazon and they are 3/64” thick. Sounds pretty thin. I know it’s probably not the best tool but if it will work then I was going to do that since I already had it. If it may be harder to do a good job then I’m fine borrowing ir buying the best tool for it.

I used my quarter sheet sander on it also to make it nice and flat, and get rid of any burrs left behind.

 

[cardershack]

View attachment 229417 View attachment 229418 285/55/20 KO2
Bilstien 5100’s on all 4 corners

What did you have the fronts and rears height set at? I can’t decide if I want to level my Tahoe or just bump it up 1-1.5” all around. I don’t think the slight rake looks bad and I really just want a stock look just a tad taller and a larger tire. Has anyone done this?

 

[olyelr]

What did you have the fronts and rears height set at? I can’t decide if I want to level my Tahoe or just bump it up 1-1.5” all around. I don’t think the slight rake looks bad and I really just want a stock look just a tad taller and a larger tire. Has anyone done this?

 

[iksplizit]

Bottom picture is stock, the picture above it isleveled with 33's and the first picture is 6 inch fabtech on 35's

 

[TomK9er]

View attachment 377634View attachment 377635View attachment 377636

Did you trim the front air dam using a saw of some sort or were you able to remove it somehow?

 

[MikeK1981]

Did you trim the front air dam using a saw of some sort or were you able to remove it somehow?

Oscillating multi tool cut through mine easily. Sanded the edge smooth when finished.

 

[Sparksalot]

Did you trim the front air dam using a saw of some sort or were you able to remove it somehow?

I used a cutoff disk in my angle grinder to trim mine.

 

[cn27]

22 denali xl 6 inch lift, brembos, 35 inch before ats, corsa exhaust....more ro come

 

[TomK9er]

Oscillating multi tool cut through mine easily. Sanded the edge smooth when finished.

I haven’t crawled under to look, is it one piece with the front bumper? I was hoping it was separate and attached somehow and could be removed.