Slow fuel fillup

[Fless]

You can see the hose and cross member through the left rear wheel well. I thought I posted a pic a while back but can't find it. I might've dreamt it.

One post about the damage is here: https://www.tahoeyukonforum.com/thr...s-gmt900-tahoe-yukon-today.44151/post-1590601

and this is the pic:

 

[iamdub]

One post about the damage is here: https://www.tahoeyukonforum.com/thr...s-gmt900-tahoe-yukon-today.44151/post-1590601

and this is the pic:

View attachment 355649

You rock!

Damn- I posted incriminating pics AND a confession! Hey @Matt06Yukon, this is what happens when you don't pay attention. There's not much slack in that vent hose, so you have to get the tank close to the cross member it rests against, then route that hose over it and continue lifting the tank into place. Don't forget to disconnect it before dropping the tank, either.

You can get an idea from the pic of where to look from the wheel well to see if it's pinched. If not, disconnect the tube from the EVAP canister to isolate the problem to that or the tank.

Thanks for finding that, Steve.

 

[Fless]

I'm kinda tuned in to evap issues, since I went through a *few* on my NBS, so I was paying attention when you posted your saga. I'm glad my lines don't have to run over any crossmembers!

 

[Matt06Yukon]

Interesting. Ok, Thanks man, I'll definitely have to take a closer look. Its getting cold around here and the truck is gonna be hibernating for the winter. I should have plenty of time to check it out.

 

[Matt06Yukon]

Nice truck, nice garage! Have you sealed that concrete floor yet?

Thank you!
No I haven't, I'm kinda waiting for it to settle, see if any cracks develop. Then later I'll epoxy coat it. I gotta finish this addition and pave the driveway first.