Snapped EZ Out in Broken Knock Sensor Stud. About to lose my mind

[HiHoeSilver]

Thanks guys but I got it out. Used a dremel to grind away the EZ Out then started drilling the stud out and then used helicoil.


Sent from my iPhone using Tapatalk

Good news! Tbh, I was hoping for a 6.0 swap. Lol

 

[Kaeden]

Good news! Tbh, I was hoping for a 6.0 swap. Lol

Oh that’s the plan sooner or later [emoji57]


Sent from my iPhone using Tapatalk

 

[Warriorpluto]

If i had that problem i would've relocated the sensors on the side of the block. This is the reason i avoid gen3 engines when doing engine swaps

 

[Kaeden]

If i had that problem i would've relocated the sensors on the side of the block. This is the reason i avoid gen3 engines when doing engine swaps

Yeah turns out there is actually a relocation kit I believe. I’m not positive of that but I had a buddy tell me that. Oh well though I guess. Managed to get the sensors put back in their original places and got some cleaning up done while I was in there.

 

[dmad1]

Recently viewed a video on Youtube on welding a bolt and nut to a broken stud and backing it out.