[SOLVED] Fast blinking after Turn Signal LED bulb swap

[Tom Joad]

Hi guys..

I've boughts LED bulbs for my turn signal/hazard few weeks ago.
When I replace even only 2 out of 4 bulbs I noticed that the turn signal was really fast though the hazard signal was still at normal speed.

To fix this I only had to replace the OEM thermal flasher which is set under the dash panel, with a Novita LM487 enectronic flasher.

I did the swap today and I tell you this works without adding any resistor : both hazard AND turn signal blinks at a normal rate.

https://www.amazon.com/Novita-LM487...hoe&keywords=2003+chevroelt+tahoe+led+flasher

 

[05Single]

I need to get this and throw away my ugly resistors

 

[05Single]

Was it an easy install ? Pics?

 

[OhFourChevy]

It's a really simple install, pull your old flasher from behind the kick panel under your steering wheel, easiest way to find it, is turn on your hazards, and it'll be a large relay that buzzes when your hazards click.

Simple pull and replace, the factory one is in there pretty good, just FYI, takes a bit of pulling to get it out

 

[05Single]

Yea I was reading and someone said it was a pita to replace. I couldn't imagine it being too hard.

 

[OhFourChevy]

Yea I was reading and someone said it was a pita to replace. I couldn't imagine it being too hard.

It's not, it's really simple

 

[Tom Joad]

Yes, really simple.
I'll post pics this evening.
Remove the panel in front of your knees, you'll see a metal part. Behind it you'll see the OEM flasher, pull itwith a light move fron front to back then replace the LM487 there. Enjoy.

 

[Tom Joad]

I bought this one :


Remove this panel (2 screws with hex head. 6 or 7 mm).


Unplug the blinker and replace with the new one :

 

[05Single]

Oh haha its literally right there. Eazy peezy

 

[05Single]

What year is your tahoe tom?