Tonyrodz's Tahoe Build Thread

[07Burb]

Shit replace them with some cheap copper ones instead of putting those back in, especially #8 because that one might be the problem. Coppers are only a couple bucks apiece, then come spring put the good ones in when you have the cash.

exactly what I was going to post. Definitely can't hurt for less than $20.

 

[07Burb]

Well, well. Lookey lookey--View attachment 266286 View attachment 266287
This is #7. See anything wrong?
Plus it was gapped at .040

douchenozzle just grabbed junk plugs out of a box and threw them in. Wrong plug completely. I'd definitely be checking #8, too, for sure and do what Mark suggested with replacing all 8 ASAP.

 

[Rocket Man]

Well, well. Lookey lookey--View attachment 266286 View attachment 266287
This is #7. See anything wrong?
Plus it was gapped at .040

Mismatched plugs...get #8 out, and change them all. You need to eliminate this as an issue. Get with it, no excuses!

 

[Tonyrodz]

Mismatched plugs...get #8 out, and change them all. You need to eliminate this as an issue. Get with it, no excuses!

Gonna do it tomorrow. I have about an hour of daylight left so it's going to have to wait until tomorrow, but I'm definitely going to do it.

 

[Rocket Man]

Gonna do it tomorrow. I have about an hour of daylight left so it's going to have to wait until tomorrow, but I'm definitely going to do it.

Attaboy.

 

[Tonyrodz]

I still believe in Karma. What goes around, comes around. I'm sure something is gonna bite him in the ass 1 day.
@Sam Harris I finally got the new motor cold start vid

 

[wjburken]

I still believe in Karma. What goes around, comes around. I'm sure something is gonna bite him in the ass 1 day.
@Sam Harris I finally got the new motor cold start vid

Oh yeah!

 

[Sam Harris]

I still believe in Karma. What goes around, comes around. I'm sure something is gonna bite him in the ass 1 day.
@Sam Harris I finally got the new motor cold start vid

Very nice! I’m so glad you looked at those plugs!! Need to get a whole new set in there pronto!

 

[Tonyrodz]

Very nice! I’m so glad you looked at those plugs!! Need to get a whole new set in there pronto!

Yes sir, gotta get down to Advance tomorrow. Not looking forward to laying on top of the motor again.
Does anyone know what the gap should be? I found this--
But I also found that the platinum--AcDelco that was in it--should be gapped at .040. Anyone know for sure? Opinions? I think I MIGHT go with the Delco's 41-962, unless someone has a better plug. Opinions?

 

[Bear77]

Found similar but the iridiums that I got were gapped at 40 or 45. I just went with what they were


Sent from my iPhone using Tapatalk