pwtr02ss
Full Access Member
Looks like his beaver, with how its chewed up
Tonyrodz's Tahoe Build Thread
- Thread starter Tonyrodz
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Looks like his beaver, with how its chewed up
Sparksalot
Supporting Member
What for? He’s gonna run uncorked for authentic raceway sound!
I meant to tell ya, check the plugs first to make sure they match before you rip it out.
kbuskill
***CAUTION*** I do my own stunts!
I meant to tell ya, check the plugs first to make sure they match before you rip it out.
Oh, so this is all your fault!
OP
OP
Tonyrodz
Resident Resident
This pos truck!! It was easier to get the old one out then the new one in. I must've chased those threads in the bung 20 times. Each time it was fine, until I tried getting in the new O2. That ***** would not go in. Almost like the threads were stripped. I even brought back the old one because the threads looked rounded. I tried to thread the 2nd one in--same shit. I just don't understand. The 2nd one seemed like it was going in--started to snug and seemed like it was getting tight--there were still a few more threads to go--got really snug then it got totally loose and popped out in my hand. This happened like 10 times. Finally i got it snugged enough that I just left it alone. There's still some threads hanging out.
I don't really know what to do. I know it's going to pop out of the bung if I drive it. I tried wiggling it and it's not moving at all, but if I would've kept tightening it, it would've popped out in my hand again. I was under that truck all day. I'm literally shivering my ass off. I guess Monday I'll call that mechanic and get it done correctly.
I don't really know what to do. I know it's going to pop out of the bung if I drive it. I tried wiggling it and it's not moving at all, but if I would've kept tightening it, it would've popped out in my hand again. I was under that truck all day. I'm literally shivering my ass off. I guess Monday I'll call that mechanic and get it done correctly.
OP
OP
Tonyrodz
Resident Resident
Any ideas what's going on?
Scottydoggs
Full Access Member
the threads from the bung came out on the old o2, seen that on the first set of o2 pics.
you could try a washer or two to take up some space, or best bet is to get a new bung welded in.
you could try a washer or two to take up some space, or best bet is to get a new bung welded in.
Maybe pull your skirt up a bit and show your hoe some leg, maybe go high enough and show your thongs? Idk...
Sent from my iPhone using Tapatalk
