What did you do to your 2015-2020 K2XX Tahoe/Yukon Today?

[LT1ZOB]

Oil change, lube.

 

[brucebruce45]

Finally got it tuned and magnaflow installed. Scoots pretty good now

 

[humer101]

Finally got it tuned and magnaflow installed. Scoots pretty good now

View attachment 236153

Any cold start videos?

Sent from my Pixel 2 XL using Tapatalk

 

[brucebruce45]

Any cold start videos?

Sent from my Pixel 2 XL using Tapatalk

Nah I don’t. Just a nice mellow tone to it. Removed flap and Kept all the resonators

 

[humer101]

Nah I don’t. Just a nice mellow tone to it. Removed flap and Kept all the resonators

Ok


Sent from my Pixel 2 XL using Tapatalk

 

[kiwi]

Did my second scheduled maintenance.
Oil change, new cabin filter (15k km and it was very dirty, decided to change it myself every 5-7k km), some winter preparations - cleaning/oiling power steps, rear ammo cleaning, greasing for locks and all rubber seals.

Dealer did not find the 4wd service reason again said they do not see any errors at all..

 

[SARNCAN]

Dealer did not find the 4wd service reason again

What do you mean by that? Have they refused to change transmission fluid? If so, what is your ODO reading?

 

[kiwi]

My ride showed 4wd service notification and tried to switch to 4wd lo while i was driving in 2wd mode. OFC i didn't even touch the knob.

As for the transmission fluid change, campaign is not active here yet.

Besides i don't think its fluid issue, i assume my TCM module is buggy.

 

[BlackYukon]

Wrapped the new esky mirrors since I didnt do blinkers...

Sent from my SM-G975U using Tapatalk

Did you disassemble the mirrors to wrap the blinkers? I got my Esky mirrors in yesterday and want to wrap the blinkers before I install them.

 

[K2 Kaiju]

Did you disassemble the mirrors to wrap the blinkers? I got my Esky mirrors in yesterday and want to wrap the blinkers before I install them.

Nope. I have a 4" roll left over from doing the the door trim. Cut it in half and just a little longer than the length (including around inside where mirror is). Peel, stick, and trim with razor. I got a cheap install kit off amz for like $10 when I did the doors. A heat gun is useful for setting the wrap in curves. Im new to the wrapping bit, but its pretty straight forward and simple; if you mess up, just peel it off and grab another piece...

Sent from my SM-T580 using Tapatalk