What did you do to your NBS GMT800 Tahoe/Yukon Today?

[Tonyrodz]

Installed the NNBS Escalade shifter on the Escalade today, looks so much better and feels a lot better in your hand too, ignore the crappy looking HVAC unit I had to send mine out to get fixed once I get that back and the dash bezel on the interior will look great the brown on the handle goes with the wood grain on the Escalade trim






Sent from my iPhone using Tapatalk

How did you wire the tow button?

Put the welds on for carlisle today

Have you tried to restore your headlights? Truck looks great.

 

[eand28]

How did you wire the tow button?

Have you tried to restore your headlights? Truck looks great.

Haven't tried. Will probably buy new oem ones

 

[95escahoe]

How did you wire the tow button?

Have you tried to restore your headlights? Truck looks great.

I’m going to make the harness so I’m not hacking up the new shifter


Sent from my iPhone using Tapatalk

 

[Countryboy07]

Put the welds on for carlisle today

Looks great with the welds and sitting at that height. Debadge/demold and remove the running boards and run it! Coming along nicely

 

[eand28]

Looks great with the welds and sitting at that height. Debadge/demold and remove the running boards and run it! Coming along nicely

Thanks. I was surprised the 275/55's didn't rub that bad stock height. Only rubbed turning right


Sent from my iPhone using Tapatalk

 

[inmypassatlife]

Went to the dealership for an alignment. Found out I need a vehicle inspection as well.

They failed my truck for the HIDs, various LEDs, my foglights dont work, and the rear bumpstops for not being installed.

I argued the bump stops because per VA state inspection manual only suspension bushings or components that attach to the axle that causes it to move out of alignment can result in an auto failure. I called my trusty local shop and they said put factory halogens in and remove the fog lenses and they will slap a sticker on her.... going to them on Monday.

Only reason I didn't go the the shop first was because I didn't think they could do an alignment with 22" wheels. Most places around me only do up to 20s

FFS the dealer wanted to fail me for LEDs in the reverse and tag lights.

So....youre

Are they done?

Nah, keep having shit come up

Last night the truck was stalking in reverse and in gear. Today I cleaned tps, throttle body, and reoiled air filter. Runs fine again. But working in 100* heat even with a shop fan puts a toll on me

 

[bottomline2000]

Finally started working on my interior. Just tightening up the drivers seat..Thats a lot of dead Katz!

Sent from my SAMSUNG-SM-T377A using Tapatalk

 

[eand28]

Speaking of katskinz. I need a red interior now

 

[brian.roberts.1293]

Ok guys what is the name of the plastic puddle light under the side mirrors? I've broke the tabs on both minegetting them out to replace bulbs and cannot find them online anywhere to purchase.

Sent from my SM-G965U using Tapatalk

 

[ArcticYukon]

20x10 Hostile Sprockets -19mm offset
275/60R20 Tires

The tires are just junk used ones until I decide on what to put on it. I'm torn right now, I work at a Firestone independently owned shop so I'm either looking at the Firestone Destination A/T or the Bridgestone Dueler Alenza Plus. I won't be doing any offroad driving, just highway and in town. I like the look of the A/T but the performance of the Alenza is unparalleled...like I said...torn lol

How much did you have to lift it to fit them?