What did you do to your NBS GMT800 Tahoe/Yukon Today?

[SteveB]

Replaced the oil pressure sensor again. Back to showing correctly in the dash. Last replacement was with a genuine AC Delco part, and so was this one. Hopefully this one lasts longer that a few months! At least it was within warranty.
ETA: regarding my replacement cluster, and fuel level, I decided to just leave it as-is. The over-full indication levels itself after about an eighth of a tank, then seems pretty accurate. Digital Dash Solutions did offer to swap it if I wanted to but I decided to keep this one, since it evens out after a bit.

You just sealed the deal for me. Blue leds with the stock needles.

 

[BADRIDES]

Replaced the oil pressure sensor again. Back to showing correctly in the dash. Last replacement was with a genuine AC Delco part, and so was this one. Hopefully this one lasts longer that a few months! At least it was within warranty.
ETA: regarding my replacement cluster, and fuel level, I decided to just leave it as-is. The over-full indication levels itself after about an eighth of a tank, then seems pretty accurate. Digital Dash Solutions did offer to swap it if I wanted to but I decided to keep this one, since it evens out after a bit.

Which bulbs did you use for the blue back lighting on the cluster?

 

[Sam Harris]

Which bulbs did you use for the blue back lighting on the cluster?

I didn’t do it myself. I cheated, and bought it from Digital Dash Solutions. (eBay)

 

[Sam Harris]

You just sealed the deal for me. Blue leds with the stock needles.

Hehe. Nice. Yeah, I like the stock needle color. I wasn’t sure about the blue, since the Yukon is maroon, but it’s definitely my favorite color. Like the orange better than the silver or blue needles.

 

[Bombsquad85]

Which bulbs did you use for the blue back lighting on the cluster?

Judging by the uniformity of the light I'd say an LED strip was used. Thsts what I did and mine looks great imo

****** picture but you get the point

 

[Rocket Man]

Judging by the uniformity of the light I'd say an LED strip was used. Thsts what I did and mine looks great imo

****** picture but you get the point

View attachment 232381

Why do you say that, when the stock lights also create even light. That company replaces bulbs with led, they don’t use strips. I did mine using leds and not strips and it looks great.

 

[Rocket Man]

I started out painting my grills a darker color and progressed to painting my exterior handles but ran out of time.

 

[mikeyss]

Odd question, and I ask because my truck didn't have the owners manual when I bought it. My 06 SD has auto dual zone HVAC. Is there a way that when you adjust the drivers side temp that it controls the passenger side too? I don't often have passengers in it, and in Colorado, in the morning you need full heat, but by afternoon you need almost full A/C... I get tired of having to set both sides. My 09 has a pass button that activates the dual zone separate temps.

 

[Scottydoggs]

you ever try just hitting the AUTO button and see if it adjusts to your liking?

other then that, you need to turn both knobs to lower or raise the heat on both side equally.

 

[Sam Harris]

Odd question, and I ask because my truck didn't have the owners manual when I bought it. My 06 SD has auto dual zone HVAC. Is there a way that when you adjust the drivers side temp that it controls the passenger side too? I don't often have passengers in it, and in Colorado, in the morning you need full heat, but by afternoon you need almost full A/C... I get tired of having to set both sides. My 09 has a pass button that activates the dual zone separate temps.

IIRC, if you press and hold the Auto button for 3 seconds, that syncs both sides. Any change to the passenger side will un-sync the sides though.