What did you do to your NBS GMT800 Tahoe/Yukon Today?

[blueinkd]

Niiiiiice… check those pushrods carefully.. lifter trays..? Cam retainer plate / seal..? You’re doing the oil pump.. might as well do a timing set.. cam position sensor..? Knock sensors & harness..? Sorry, I -like many on this forum- enjoy spending other people’s money..

I have all that new as well, was just too much to type. The knock sensors are oem Delco less than 6 months old, harness is new, cam sensor/oil press is oem same time I did knocks a while bCk. Was hoping that P0302 was a simple fix but here we are.=/

 

[adventurenali92]

Who can recommend a good product to cut & buff my roof, and probably going to need under these badges as well… @adventurenali92 …?

Your porter cable and pads will work great. Check out P&S detail products by renny doyle. A little pricey but with every penny. He’s got a couple polish products I always have on hand for detail work. Run the smaller 5 inch pads on your rooter cable for the area up on the roof in-between the roof lines to get good results.

 

[Sam Harris]

Your porter cable and pads will work great. Check out P&S detail products by renny doyle. A little pricey but with every penny. He’s got a couple polish products I always have on hand for detail work. Run the smaller 5 inch pads on your rooter cable for the area up on the roof in-between the roof lines to get good results.

Thank you! I already have some Chemical Guys VSS, I forgot about. Any thoughts on that?

 

[MassHoe04]

Mileage OCD got a treat on the way home from work yesterday... This is my daily.

 

[Walchit]

Just ordered Truck Norris!!!
Looks liked the correct one for my 05 5.3 tahoe correct??

The other one is called "NSR" (no springs required)
I wish mine would have came with that cool bald eagle box!

 

[Walchit]

Trying to wash 300k worth of grease and grime out of this thing, then gonna mess with this wire loom hopefully.
This picture makes me want to order a stall so bad.
Anyone heard any reviews on the BTR "Truck Yeah" converter? It's hard to find on Google and youtube.

 

[treehan77]

Did both the steering box tighten about 3/8 of a turn and the column tighten 1/4 turn, feels quite a bit less sloppy now.

 

[mattbta]

Yesterday picked up some mulch and stone for my dad with it. Didn’t realize he intended me to also install.

Assembled/loaded this grease gun I got after my thread here. Wow, the adapter and the loading mechanism are amazing. Hopefully no leaks.

Greased the rear sway and panhard. Will do the front this week when I get it in the air for an oil change.

 

[Mudsport96]

Nothing special, put the old 4114 bulbs back in the DRLs since one of the LEDs died. Apparently the Driver side drl/turn signal housing has a leak. Had a half inch of water in it that wasnt in there 2 days ago. We did have a few storms the last few days but damn. Well.... guess it is time for some fancy lenses.

 

[Walchit]

Got a couple wires loomed up, it's kinda tedious. Hopefully it doesn't rain tomorrow.