What did you do to your NBS GMT800 Tahoe/Yukon Today?

[Sam Harris]

 

[ivin74]

Fixed it.. apparently, the switch was bad. Looked very clean, but used some Electronic cleaner just because.. and a dab of dielectric grease.

Did you buy a new switch? I'm having the same issue on my Yukon

 

[iamdub]

 

[blueinkd]

New tailshaft housing, seals and I also replaced the orig that goes around the small sleeve around the output shaft. Fighting a small leak coming from the tail shaft. Hopefully this fixes it otherwise I'm getting it rebuilt sooner than later.

 

[Scott in AZ]

Replaced O2 sensor. Cleared code. Hopefully fixes issue. Washed and pulled it in the shade for a wax.
View attachment 405945View attachment 405946

Good looking rig.

 

[Jonesy92]

I finally my mounted my 33's this weekend. Hoping to finish my one-off roof rack this coming weekend.

 

[Sam Harris]

Did you buy a new switch? I'm having the same issue on my Yukon

Yessir. I suspect I could have fixed the original, and have saved it for future use, but thought I’d give a new Dorman a shot for 12 bucks.

 

[MaleHoe]

I bought some new wheels. Now I just need to find some tires with the right fit.

 

[MaleHoe]

View attachment 406472
I finally my mounted my 33's this weekend. Hoping to finish my one-off roof rack this coming weekend.

I like the purple.

 

[polargeek]

Today was a busy one. Replaced the front and rear shocks, new compressor, front hubs and rear brakes. My 2002 Escalade feels a whole lot betters