It would start to leave a oily, dirt contaminated trail on the pipe line it if it does.
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
- Thread starter phattyford
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
It would start to leave a oily, dirt contaminated trail on the pipe line it if it does.
Thanks gents. I have new spares plus the tool already, and am kicking myself for not putting them in. The low side is only a couple years old and is fine, but I knew the high side was probably due and I just rolled the old sleeping dog dice. I’ll take it up to the shop and have it evacuated again this week.
Did you try pushing down on the ball and letting it pop back into place? At least in mine, the high side has a ball bearing type of thing that pushes up against an o-ring or seal. It’s similar to a schrader valve in that it has a spring but instead of the pin type thing it has a ball. Maybe a bit of dirt got in it. Of course you might make it worse too.
Did you try pushing down on the ball and letting it pop back into place? At least in mine, the high side has a ball bearing type of thing that pushes up against an o-ring or seal. It’s similar to a schrader valve in that it has a spring but instead of the pin type thing it has a ball. Maybe a bit of dirt got in it. Of course you might make it worse too.
Yup can try that too! The old valve love tap!
LOL, I bought 2 lots of 30 I figure i'm gonna need those sob's sooner or later next time a window regulator or some crap gives up the ghost.
drove her up to Bear valley to play in the snow, there is about 12' of it up there around 5-6000 ft, cold about 23deg and windy
she had ice-cycles underneath but ran perfect and nice and warm inside.
she had ice-cycles underneath but ran perfect and nice and warm inside.
Yep, I did. No joy. :-(Did you try pushing down on the ball and letting it pop back into place? At least in mine, the high side has a ball bearing type of thing that pushes up against an o-ring or seal. It’s similar to a schrader valve in that it has a spring but instead of the pin type thing it has a ball. Maybe a bit of dirt got in it. Of course you might make it worse too.
Tonyrodz
Resident Resident
replaced the passenger side mirror, mirror works fine but in the process the triangular trim piece broke a clip off and almost all the door panel clips broke off
so if you plan on pulling door panels off of a 10+ year old vehicle invest in some of these, gm wants about $8 each
30 Pcs 11519031 Door Panel Clip W Sealer Trim Retainer For GMC Envoy Hummer H2H3 | eBay
Find many great new & used options and get the best deals for 30 Pcs 11519031 Door Panel Clip W Sealer Trim Retainer For GMC Envoy Hummer H2H3 at the best online prices at eBay! Free shipping for many products!www.ebay.com
Just went back to reread Wes's post!
prices are going up usps increased shipping prices yesterday and took away regional boxes which is going to cost me about $1000-2000 more a year in shipping. maybe more
Just went back to reread Wes's post!
