What did you do to your NNBS GMT900 Tahoe/Yukon Today?

[wjburken]

I wish, o'l Gavin Newsom would have a baby cow if I did though

 

[DaRosa218]

Cut and buffed the paint using Griots products, Silver Birch always looks best glossy

 

[Rocket Man]

Cut and buffed the paint using Griots products, Silver Birch always looks best glossy

I thought most of them look best glossy except the flats...

 

[Kee Fuller]

Replaced the leatherish skin on my center console. Doesnt look bad, but i can tell its a cheap quailty off ebay.

Installed the cabin filter too. That was a pain in the ass. Sprayed the coils with coil cleaner and i dont think i got it all, but its cleaner than before.

 

[Woodblocker55]

New skins 10 ply snow and towing tires yes I will put them on myself that way yellow dot ends up by the stem . They are so stiff of sidewalls it's going take a cheeta blast to get them to seat ya on a 6.5 rim even. There full wrap nylon steel belt radials . Get this with stepped ribs on tread to keep rocks from pinching between face tread. And pinned for studs [emoji849][emoji15] ya total over kill. [emoji106][emoji41] Each tire can handle 3042 lbs . Tire manufacturer told me to just put the air in that's recommended for the vehicle. That's like 34 lbs they can handle 80 psi. Next project is air bags in back coils [emoji106]

Sent from my LGL84VL using Tapatalk

 

[Rocket Man]

New skins 10 ply snow and towing tires yes I will put them on myself that way yellow dot ends up by the stem . They are so stiff of sidewalls it's going take a cheeta blast to get them to seat ya on a 6.5 rim even. There full wrap nylon steel belt radials . Get this with stepped ribs on tread to keep rocks from pinching between face tread. And pinned for studs [emoji849][emoji15] ya total over kill. [emoji106][emoji41] Each tire can handle 3042 lbs . Tire manufacturer told me to just put the air in that's recommended for the vehicle. That's like 34 lbs they can handle 80 psi. Next project is air bags in back coils [emoji106]

Sent from my LGL84VL using Tapatalk

I wanna see those when you get them on!

 

[avalonandl]

Just cut the cats out like I did and you don't have to worry about it anymore [emoji1745]

He can't he is in Commiefornia where the.... nevermind...

 

[Fosscore]

Looking at the overflow tank cold on the NNBS and it hasn’t been driven this morning. Shows below the full line.

Do I need to fill it up to the line or leave it as is for expansion?

 

[Doubeleive]

Looking at the overflow tank cold on the NNBS and it hasn’t been driven this morning. Shows below the full line.

Do I need to fill it up to the line or leave it as is for expansion?

View attachment 230169

You can try to make it stay on the full cold line, mine won't unless I have it done on the machine at the dealer, but I'm going to try again as well

 

[Fosscore]

You can try to make it stay on the full cold line, mine won't unless I have it done on the machine at the dealer, but I'm to try again as well

View attachment 230171

So either way, we are close to where we need to be at cold temp then? It looks low, but not actually too low to be too concerned about is what you are saying?