What did you do to your NNBS GMT900 Tahoe/Yukon Today?

[Tonyrodz]

Pics as stated above

View attachment 253523 View attachment 253524 View attachment 253525 View attachment 253526

Are you tuned for it? Great looking piece.

 

[1BADI5]

Are you tuned for it? Great looking piece.

Yes, my truck is tuned and Thank You!

I still have my 102mm TB to install, but I know I will get a lean code.......so I'm going to install it right before it goes back on the dyno on Wednesday

 

[89Suburban]

Sweat my ass off this weekend installing the FAST LSX r/t intake and my Go Rhino protester bar

Pics to follow

"Protester" bar love it, what perfect timing LOL.



I want one of those, where did you get it from?

 

[89Suburban]

Got this delivered by USPS today. Who knew, on a Sunday!

Won't be able to install it this week though, gotta wait till next week.

Sent from my SM-G930V using Tapatalk

i NEED TO DO THIS.

 

[Doug118]

Finally got a good shot of the notch

 

[Sam Harris]

"Protester" bar love it, what perfect timing LOL.



I want one of those, where did you get it from?

X2. Awesome

 

[Sam Harris]

Yes, my truck is tuned and Thank You!

I still have my 102mm TB to install, but I know I will get a lean code.......so I'm going to install it right before it goes back on the dyno on Wednesday

Been thinking about a big TB and intake combo.. what about the air intake tube? You know of one that’s a 102mm..?

 

[5strmtrp]

The seal that slips over the metal lip around the entire perimeter of the opening? You have part numbers? I need to replace my driver's side. The oil spill from last weekend deteriorated the foam rubber.

Here you go:

Passenger side RIGHT. 22766410

Drivers Side LEFT. 22766409.

These are the ones that go over the metal pinch weld around the doors.

DO NOT USE GM PARTS DIRECT. Horrible service never get a response, all they do is open trouble tickets and leave you hanging by your nuts. I’m still waiting for 2 items from them that I ordered June 20th.

 

[Rocket Man]

Finally got a good shot of the notch

View attachment 253534 View attachment 253535

Noice notch.

 

[08z71bgm]

Well I finally got the brackets. QC is a bit to be desired. They should really make sure the water jet cuts the holes 100% before packaging. Maybe clean it up a bit too. I know maybe I’m being too critical for 75 bucks. Lol also no washers for the bolts.



edit: so it’s also going to need to be deburred. The edge is quite sharp. I’ll most likely hit with a file and add rivnuts in the holes. Then paint the whole thing.