What did you do to your OBS GMT400 Tahoe/Yukon Today?

[chaingun427]

Got the bubbles cleaned up and primed in the rear floor board, might have a line on an ls engine a well for that swap

 

[Gzes]

Finally did the blend door actuator. Holy crap that was annoying. Still gotta do egr and oil cooler lines

 

[lonnel26]

might as well do the DIZZY while u are at it

Ordered dizzy

 

[jerryjoe28]

Ordered dizzy

lol you wont regret it

 

[chaingun427]

Mopped up more water from the back. Apparently there is a recall on the barn door seal and I'll need to buy a new one

 

[I go every where]

Got my exhaust done again. Got rid of both the cats and did straight 2.5 pipes all the way back with 4x18 tips. That was too loud so I had him put an H pipe in and now im satisfied! The rumble it has during idle makes me wet myself

 

[Gzes]

The 2dr is finally getting new ac done

 

[SunlitComet]

 

[neosoul]

finally got my spider injector replaced, along with new cap and rotor, fresh antifreeze, new synthetic blend engine oil. next up will be a new starter

 

[bigal11419]

Changed the oil and oil filter, replaced headlight assemblies and parking lights. Swapped out corner lights and reverse lights for leds. Replaced weather stripping on liftgate, rerouted wiring for the reverse camera and replaced the wiper blades.