What did you do to your OBS GMT400 Tahoe/Yukon Today?

[96ProCompTahoe]

got the heads and upper intake cleaned up and ready to put it all back together. hope to have the intake fully reinstalled tomorrow evening if all goes to plan. giving myself till monday evening to have it up running (unless i get screwed with having to scan it for a crank relearn).

 

[SunlitComet]

wont need a crank relearn. you would need a CAM_RETARD alignment.

 

[96ProCompTahoe]

wont need a crank relearn. you would need a CAM_RETARD alignment.

thought that sounded off, sunlit for the save!

 

[qukon 95]

I put a new gates belt on & the tension pulley wheel no more squeaks.

 

[SunlitComet]

Stared at it again.

 

[96ProCompTahoe]

Lower intake and dizzy back in place. Spider and upper going on it after work, hoping to have it back together this afternoon

 

[SunlitComet]

Looking forward to the results and pictures.

 

[Gates72ss]

Pulled the trans out , hoping to find my issue...Hoping it is the servo and not blown....

 

[AtomicHoe094]

Getting the right AC bracket for my truck and hopefully getting this whipple done this week. My old AC bracket came with a smog pump from when i grabbed the motor from a 92 K5blazer. The whipple was designed without the smog pumps..

 

[96ProCompTahoe]

Looking forward to the results and pictures.

i won't lie i've been skimping on the pictures as time has not been on my side and i'd rather not have an I Phone screen covered with oil i'll take some of the current state and the new spider installed in it atleast.

Still amazed that the lower intake only gets torqued to 11 ft. lbs.... seems was to loose?