Window trim

[BigdawgR6]

Yep.... definitely getting it wrapped should I ever go this route lol.

Look great man and the dedication was strong on this project.

 

[66 Galaxie]

How were the other trim pieces attached, any challenges.

 

[Doubeleive]

this. I didn’t even know what a rivet was until I ran i to this. They come off very easy with a drill, literally 5 seconds of drilling

good thing you asked instead of just trying to rip it out, that wouldn't have been pretty, the metal on these trucks is so thin now a small tap on it and it dents.

 

[blkonblk]

Yep.... definitely getting it wrapped should I ever go this route lol.

Look great man and the dedication was strong on this project.

lol I don’t know if I would call it dedication but finally got it done lol

 

[blkonblk]

How were the other trim pieces attached, any challenges.

I have pics for anyone trying to do it, I might do a write up. For lower pieces there are two crews on each side and they pop right off. Not a difficult project once you get over the drilling part of these rivets

 

[blkonblk]

just did the rear bumper trim as well, oem part number 84371058

 

[blkonblk]

Dropped the headliner and replaced the roof rails. While I had the headliner out I also ran wires for front/rear dash cams and installed minimal starlights in headliner. Painted the calipers red and this weekend ceramic coating it