285/70/17's on 03 yukon

[red yukon]

i've got an 03 yukon slt. i'm planning on getting dick cepek torque wheels (17x8.5) for it and 285/70/17 fierce attitude MT tires for it. i already cranked the torsion bars on it. i know i might have to trim a little bit but i want to make sure this setup will fit. ps i am new to this site.

 

[AquinoSteven]

Since your still running stock keys you may have to trim quite a bit but if you go with some aftermarket keys youll be set.

 

[swtz71]

you will rub.. you will need to crank sock keys to start, see how it goes but lift keys and rear spacers would be better..

 

[red yukon]

thanx for the info i knew the backspacing of the wheel was going to be the biggest problem it doesnt bother me to trim a lot

 

[swtz71]

just be careful not to trim to much on the drivers side front inner fender well, the washer reservoir is there..

 

[red yukon]

thanx for the info

 

[DaRosa218]

I have 295/70r17 on ready lift keys and rub on the inner fenders. It's manageable but you do rub a bit

 

[Frankhenrylee]

I've been wondering about moving the washer fluid tank to a less restrictive location. Anyone on here ever done that?

 

[DaRosa218]

I've been wondering about moving the washer fluid tank to a less restrictive location. Anyone on here ever done that?

Mine was cracked and leaking so I just yanked it out. You'll just get a low washer fluid warning every time you start the truck.

 

[AquinoSteven]

Not really worth moving. If your tire hits that im sure youll have bigger problems haha