96 Two Door 6 in lift?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

bowtiefreak

No Quarter
Supporting Member
Joined
Apr 30, 2009
Posts
5,404
Reaction score
100
Location
Near Philly
Check out Rough Country 6" kit, it is nice.

A lift will not effect mileage other than more wind resistance...the mileage loss will come from the larger tires with improper gearing.
 

bowtiefreak

No Quarter
Supporting Member
Joined
Apr 30, 2009
Posts
5,404
Reaction score
100
Location
Near Philly
Brad, I did need a longer drive shaft. Two doors have a very short shaft to begin with. I believe they added about 1". I also upgraded to a CV shaft. That was an adventure of it's own getting the pinion angle correct
 

YAMBAG

Member
Joined
Aug 3, 2009
Posts
51
Reaction score
6
Location
westport MA
Awesome! So it's safe to say that putting a 6" lift on the 2doors is NOT just $1,000. It's more like $2,000 after I replace the driveshafts, front end components, modify the ypipe, buy new shocks, and then get a front end alignment.


Sent from my piece of crap iPhone using Tapatalk
 

bowtiefreak

No Quarter
Supporting Member
Joined
Apr 30, 2009
Posts
5,404
Reaction score
100
Location
Near Philly
Front shaft should be fine, rear shaft can be modified...longer was about $100 at a local driveline shop.

The Rough country kits comes with shocks, brake line and all. Nice kit. The Y pipe does need work but 100-200 at a local place is all. plus the alignment.

Wheels, tires, gears, floor mats, rust proofing. What I'm saying is yes, costs are "hidden" in projects like this. What if all the ball joints are bad? Now's the time for them
 

HortonHiresAHoe

Full Access Member
Joined
Feb 4, 2014
Posts
550
Reaction score
1,345
Location
Mt. Juliet, TN
I did not have to get a longer driveshaft or modify the y pipe with my lift. I did, however, need a new front cv driveshaft but only because I have the autotrac. Bowtie is correct... the hidden costs do add up. Figure out how much you "think" you can do it for and budget double just for the unknowns.
 

SwampHound

Full Access Member
Joined
Aug 18, 2013
Posts
132
Reaction score
5
Location
Alabama
If you went with a body lift and what you have now, you could in theory get to about 5 inches of lift for cheap. But it wouldn't look right unless it had bigger tires. And bigger tires mean lower mileage as bowtiefreak mentioned. To get back mileage and power you would have to spend another chunk of change on regearing. And to top it off, if you went with anything bigger than a 33" tire it would be preferable that you switch out your 10 bolt rear for a 14 bolt. I'm not trying to be a downer, just trying to give you some insight :)

Sent from my XT1080 using Tapatalk
 
OP
OP
bamaboy73

bamaboy73

Member
Joined
Feb 19, 2014
Posts
41
Reaction score
0
I was thinking 3 inch with 2 inch block in the back and 2 inch level? would that look okay?

---------- Post added at 11:56 PM ---------- Previous post was at 11:53 PM ----------

Check out Rough Country 6" kit, it is nice.

A lift will not effect mileage other than more wind resistance...the mileage loss will come from the larger tires with improper gearing.

that is what im looking at but what if i got the 3 inch with 2 inch bloks and 2 in level?
 

Forum statistics

Threads
132,376
Posts
1,866,998
Members
97,012
Latest member
Roscoe2352

Latest posts

Top