Corvette servo/ shift kit or both?

[stuntmanray385]

Really?! I called a nearby shop by me and they said 150..don't know if it's worth it...may have to do it on my own..

its too easy. it literally takes 30 mins. get those hands dirty!

 

[keruzam93]

there an o-ring that holds the cover in. make sure you cut that ring. try to pry it up with the flat head screwdriver. theres nothing attached to the cover so it should come right out.

i cant even see let alone cut an O ring in there

 

[stuntmanray385]

i cant even see let alone cut an O ring in there

you have to use the flathead screw driver and press the cover it. it should move inwards about 1/4 inch. press it in as far as u can get it and use a smaller flathead screwdriver put in in the notches and pry upwards.

 

[keruzam93]

thats the problem, the cover doesnt move, im not sure were your from but here in NY were half the year is covered in rock salt things dont like to move after 15 years haha

 

[stuntmanray385]

thats the problem, the cover doesnt move, im not sure were your from but here in NY were half the year is covered in rock salt things dont like to move after 15 years haha

oh lol. im in southern california soooooo i couldnt possibly relate. but if its not moving inwards then you my friend have a problem. i just did the same thing on my friends camaro. easy as pie. i would try some wd 40 or something to get that thing to move.

 

[SunlitComet]

Use a seal driver

 

[keruzam93]

Use a seal driver

idk if i could do that with it in my truck and i realy dont wanna take my trans out

 

[SunlitComet]

Dremel? Rotozip? Something really destructive

 

[retorq]

Just hit it with a hammer, what's the worst that can happen?? LOL

 

[SunlitComet]

Starter fails next time around. Or the tranny case cracks from all the corrosion.