SunlitComet
OBS Jedi-Do Good
Damn YUK you must go thru a lot of toothpicks on the condenser.
H3 HID Kit and Projector housings.
- Thread starter DefendHawaii
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Devs93
Full Access Member
- Joined
- May 29, 2011
- Posts
- 116
- Reaction score
- 0
I dont think you will fit that many ballast behind there but if you can keep some hiddin behind there you cant go wrong lol. Does the h3 bulb have a wire soldered to the terminal?
OP
OP
DefendHawaii
Snake Eater
Ok guys update for the day. My guy came by today he and I got got all the housing issues and fittings fixed. We used a relay adapter for the HID's and Ballasts. Now here is my only issue. I need to ground the pos and neg wire to the battery and get it bolted in their. Problem is the ring washers at the end of the Relay adapter that are supposed to go onto the battery are to small. Is there an adapter for that? When I put them up against the battery terminals the new HID's light up perfect. Any idea what I should ask for when I call Oreilly's?
SunlitComet
OBS Jedi-Do Good
Perhaps use the batt or aux terminals on distribution box instead.
OP
OP
DefendHawaii
Snake Eater
Dist Box? where the Fuse Relay box is near the spare battery area? Sorry So new to the Chevy world.
---------- Post added at 05:22 PM ---------- Previous post was at 05:16 PM ----------
I read that I could ground the Black wire to the vehicle frame if need be.
---------- Post added at 05:22 PM ---------- Previous post was at 05:16 PM ----------
I read that I could ground the Black wire to the vehicle frame if need be.
SunlitComet
OBS Jedi-Do Good
left side of engine compartment just forward of firewall. remove cover and look on the side of block.
OP
OP
DefendHawaii
Snake Eater
Thanks I am heading outside now to see if that will work. Is their a specific spot to ground the red and black too? I have been trying to find video installs to no avail. Still got a few hours of light out though otherwise gonna be driving with the brights on lol.
SunlitComet
OBS Jedi-Do Good
You do not ground the red you attached it to one of this posts. The black can be grounds on existing ground in the compartment just look around for black wires bolted to the sheet metal or brackets.
OP
OP
DefendHawaii
Snake Eater
Ok got it thanks! I just need to run and get a bolt and washer to bolt it to there.. I am attaching to the side not the top two parts since the relay part is still to small but the side connector will work and is big enough.
OP
OP
DefendHawaii
Snake Eater
Ok guys got it all wired up thanks for the help! 35w bulbs feel a bit weak. The PIAA bulbs that were in before were 55w so I wonder if I can toss 55w in next week.
Similar threads
