Hood

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

JLMBT

Member
Joined
Jul 19, 2022
Posts
39
Reaction score
8
So I just noticed this, my 22 yukon the hood is not flush to the body on the right side (looking at it from the front) what causes that...so that I know what to say when I take it back to the dealer, looks like it's factory defect..vehicle is new..about 4600 miles....
 

wjburken

Supporting Member
Joined
Dec 26, 2017
Posts
10,064
Reaction score
28,103
Location
Eastern Iowa
So I just noticed this, my 22 yukon the hood is not flush to the body on the right side (looking at it from the front) what causes that...so that I know what to say when I take it back to the dealer, looks like it's factory defect..vehicle is new..about 4600 miles....
Not familiar with that body style, but typically these can be adjusted to line up.
 
OP
OP
JLMBT

JLMBT

Member
Joined
Jul 19, 2022
Posts
39
Reaction score
8
This is the one not flushed...
 

Attachments

  • 20221030_091006.jpg
    20221030_091006.jpg
    194.7 KB · Views: 14

jforb

Full Access Member
Joined
Jul 13, 2022
Posts
124
Reaction score
178
Location
Sierra Vista AZ
Hmmm....I don't think adjusting will do much, it looks like the curves don't quite match.

20221030_091022.jpg
 

iamdub

Full Access Member
Joined
Apr 23, 2016
Posts
20,821
Reaction score
44,950
Location
Li'l Weezyana
This is the one not flushed...

For the record, this will be referred to as the "left side" (driver side). They go by vehicle left/right, not what you see when facing it.

That looks like they just didn't spend enough time aligning the hood and/or fender. If you were to view the hood from overhead, it's like it needs to be rotated counterclockwise. They might be able to just loosen the hinge bolts and slide that one side back. Could be slightly misformed hood or fender point and it just needs tweaking. Likely an easy fix.
 

jforb

Full Access Member
Joined
Jul 13, 2022
Posts
124
Reaction score
178
Location
Sierra Vista AZ
Moving the hood back on one side only, will also move the front of the hood sideways. The hood is a rectangle, it can't magically turn into a diamond, unfortunately.

you might find that you can bend the corner of the fender a bit, up, down, in, out, etc, using your fingers. Do this very patiently, see if you can get it to line up a bit better. Don't expect miracles.
 
Last edited:
Top