HVAC Temperature Sensor?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

EddieC

Full Access Member
Joined
Aug 9, 2014
Posts
649
Reaction score
513
Recently our 2008 Tahoe dual HVAC system needs the heat controls turned way up (80 degrees) ti get hot air from the system.
I am assuming that there is a temperature sensor somewhere in the cabin that might be needing attention or replacement.
If that could be the problem, where is it.
Any other input will be appreciated.
 

Doubeleive

Wes
Supporting Member
Joined
Nov 7, 2017
Posts
26,204
Reaction score
39,271
Location
Stockton, Ca.
Recently our 2008 Tahoe dual HVAC system needs the heat controls turned way up (80 degrees) ti get hot air from the system.
I am assuming that there is a temperature sensor somewhere in the cabin that might be needing attention or replacement.
If that could be the problem, where is it.
Any other input will be appreciated.
headliner above the 2nd row passenger seat, looks like a little mic grill. they run about $25-30 online, you can access it by pulling the headliner down enough to reach in there and unclip it.
 
OP
OP
EddieC

EddieC

Full Access Member
Joined
Aug 9, 2014
Posts
649
Reaction score
513
Last edited:
OP
OP
EddieC

EddieC

Full Access Member
Joined
Aug 9, 2014
Posts
649
Reaction score
513
I see that sensor grille at the driver's side headliner, not the back seat.
I got the new sensor in but I will warn that anyone trying that needs to be prepared to lose some skin on the hands.
The is very little slack in the wire so I had to really squeeze in there and the headliner is really resistant to giving work space.
I had to pull the wire out of the headliner grill at the sensor location, get a hand all the way in, sensor in hand, an rotate the sensor so the wire socket faced down out of the headliner to get the wires in using needle nose pliers to guide them into the sensor socket.
It's worse than trying to get a sparkplug in working in a blind spot.
 
Last edited:

Doubeleive

Wes
Supporting Member
Joined
Nov 7, 2017
Posts
26,204
Reaction score
39,271
Location
Stockton, Ca.
I see that sensor grille at the driver's side headliner, not the back seat.
I got the new sensor in but I will warn that anyone trying that needs to be prepared to lose some skin on the hands.
The is very little slack in the wire so I had to really squeeze in there and the headliner is really resistant to giving work space.
I had to pull the wire out of the headliner grill at the sensor location, get a hand all the way in, sensor in hand, an rotate the sensor so the wire socket faced down out of the headliner to get the wires in using needle nose pliers to guide them into the sensor socket.
It's worse than trying to get a sparkplug in working in a blind spot.
if there is not another one above the rear passenger or all the way in the back drivers side then you only have the one sensor.
so, then that would imply that either the blend door actuator is maybe going goofy or maybe the control panel, any other "sensors" just show the temp they do not command anything as far as I am aware.
do you have a tech2?
 
OP
OP
EddieC

EddieC

Full Access Member
Joined
Aug 9, 2014
Posts
649
Reaction score
513
No tech2.
Swapped the sensor s I'll see what happens. The original one had quite a bit of fibers in the fan so maybe that was the issue. It was not making any audible noise.
Funny, but not, that the oem replacement in a sealed GM bag had "made in China" imprinted on it.
On closer look, the original oem also notes "China Made". Disappointing.
 
Last edited:

Forum statistics

Threads
132,301
Posts
1,865,646
Members
96,885
Latest member
BinOdhaib
Top