Post your setups!!
- Thread starter bowtiefreak
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
purple 'hoe
Full Access Member
I'll post my set up with details
1995 2 Door, Superlift 6inch, 285's/75R16 on American Racing Atlas II 16x8. Rough Country Shocks.
I did have 35's for a little while, but with the factory 3.73 gears, the 35's were killing it. I'm either going to regear the 10 bolt and put a trutrac in it, or build a 14 bolt SF up before I get 35's again. My 285's still are at 11/32's of tread depth, so I have some time before I need new tires.
But eventually, I'd like to SFA it, and have a 14 bolt FF on 37's. Once it's not a daily driver, or I have a 2nd vehicle to drive, then I'll SFA it.
1995 2 Door, Superlift 6inch, 285's/75R16 on American Racing Atlas II 16x8. Rough Country Shocks.
I did have 35's for a little while, but with the factory 3.73 gears, the 35's were killing it. I'm either going to regear the 10 bolt and put a trutrac in it, or build a 14 bolt SF up before I get 35's again. My 285's still are at 11/32's of tread depth, so I have some time before I need new tires.
But eventually, I'd like to SFA it, and have a 14 bolt FF on 37's. Once it's not a daily driver, or I have a 2nd vehicle to drive, then I'll SFA it.
OP
OP
nice truck and good plans
got a tortion crank and about 2" blocks out back done by previous owner...
I added the 295/70R17 Nitto Trail Grappler M/T's on 17x8" eagle 140 series wheels
Trimmed the front bumper with a circular saw and painted a black trim on it to make it look better. Turned out alright
and just for fun.....
where did they rub? How do you like the trail graps on and off road? Good lookin truck man! How wide did they sit out passed the fender?
Thanks,
Justin
---------- Post added at 09:14 PM ---------- Previous post was at 09:05 PM ----------
Last edited:
99Yuk
Full Access Member
Finally got me a 2" block lift for the rear.
I have no other external plans. Well, repair the cancer is about it.
I'm pretty pleased with how it turned out!
I have no other external plans. Well, repair the cancer is about it.
I'm pretty pleased with how it turned out!
[/COLOR]
did the x pipe take some of the pop out?
did the x pipe take some of the pop out?
Baggedranger
TYF Newbie
- Joined
- Jul 25, 2011
- Posts
- 19
- Reaction score
- 1
Just picked this Tahoe up a couple of days ago.. This is what it looked like when I got it..
and this is what it looks like today..
The setup from what I have found out is...
6" Dick Cepek suspension
3" body lift
35x12.5 Nitto Mud Grapplers
18x9" Eagle wheels..
and this is what it looks like today..
The setup from what I have found out is...
6" Dick Cepek suspension
3" body lift
35x12.5 Nitto Mud Grapplers
18x9" Eagle wheels..
SunlitComet
OBS Jedi-Do Good
OP
OP
welcome, got a front view?
Baggedranger
TYF Newbie
- Joined
- Jul 25, 2011
- Posts
- 19
- Reaction score
- 1
Not right now but I can get one.. I need to register this thing on Wed so I'm going to be driving it then.. Here is a shot from the rear though.. lol..
Right now this is the best front that I have..
This was before I put the corners in after swapping the grille that was cracked.. Not to fond of this grille since the bowtie sits outside unlike the OEM piece.. Another friend offered me a grille that is slightly cracked which once I get I will swap back in the slightly cracked OEM unit..
